Plant molecular biology ?

I want to add 1 ug or (1000ng ) of Plasmid DNA in a reaction mixture and add water for a final volume of 50 ul. my plasmid DNA a concentration of 68.47 ng/ul in which I have total DNA volume...

22 September 2020 7,325 6 View

How much of mineral element can be served by a portion of food in comparison to recommended daily intake?

The mineral contents were calculated for a certain grains in their raw form. How can we calculate how much a given mineral, say; zinc or iron can be served by a portion of the flour sample per 100...

15 August 2019 4,731 2 View

What is the appropriate stastical software to analysis for scale data collected from infected(inoculated) and control group(non infected) of plants?

I was collected my ten scale level data from from infected and control(non inoculated) by plant pathogen. Therefore, which statistical tools is appropriate for my data analysis?

09 February 2019 6,854 9 View

What is the general behavior in relation to the correlation between the protein content and the fat content of plant foods, specifically legumes?

There are various arrays of trends and interactions between nutrients in a given food sample. The correlation between some of them is clear, as evidenced from my own result while working on the...

09 October 2017 4,377 4 View

What do the following ratios indicate in phytochemical and antioxidant study?

What is the implication of the ratio of TFC/TPC in phenolics analysis and antioxidant potency composite (APC) index? In quite a large number of articles, the TFC/TPC is estimated to be less than...

20 September 2017 2,234 2 View

Thermodynamics properties of R404A ?

Efficiency Longevity Performance Capacity Inlet and discharge gas temp. Refrigerant propertiest

01 October 2016 6,171 2 View

Which one is the best and recommended for Protein purification and characterization?

Which one is the best and recommended for Protein purification and characterization? a) Salting out (Ammonium Sulfate precipitation(NH4SO4)) b) Ion-exchange Chromatography c) Gel Filtration...

01 January 1970 7,322 8 View

How can we use a hybrid element in Abaqus Dynamic/Explicit for impressible materials?

Hi, all! How can we use a hybrid element in Abaqus Dynamic/Explicit for impressible materials? I have not find the choice for explicit element in Abaqus CAE. I am wondering whether it is possible...

25 February 2021 9,936 2 View

In which case meta-heuristics algorithms cannot minimize the network error?

Hello, I am working on hybrid neural network. I have combined ANN with two different evolutionnary algorithms to build a prediction model of 6 inputs and one output with one hidden layer of 7...

18 January 2021 7,144 3 View

What is the most suitable experimental design?

I am planning to do a study with the help of 45 farmers who are going to produce hybrid chilly seed for the first time, and I want to measure in what way semi-automated greenhouse will affect on...

14 January 2021 2,799 4 View

Hi, what is the problem , I am unable to upload my Research article. It IS asking only authors can upload while I am author?

12 January 2021 3,050 5 View

What are the dominant factors contributing to the success of electric vehicles in the marketplace?

Early innovation by Toyota via the Prius established an early adopter crowd for electronic vehicles. Since, competition in many offerings: GM (Volt, Bolt), Nissan (Leaf), and the rise of Tesla set...

02 January 2021 1,787 13 View

How to Interpret Photoluminescence Spectrum of Mixed Pb-Sn FA0.7MA0.3Pb0.7Sn0.3I3 Perovskites?

Dear Researchers, I hope you all will be in good health. I am writing this to request for your guidance. I am working on the fabrication of low bandgap Pb-Sn mixed perovskite with exact...

23 December 2020 1,147 1 View

Transgenic or Mutagenic organisms, which is more stable genetically?

Hello, Which of these genetically altered organisms is more suitable for Scientific research? Is it the Transgenic hybrids or the Mutagenic organisms? Which is more genetically stable to be used...

16 December 2020 2,049 3 View

What are best conditions for in vitro hybridization?

Hello, I would like to hybridize a probe and an anti-probe (ssDNA oligonucleotides) in a reaction vessel. What would be the best buffer to use? and the temperature of annealing? Thank you

06 December 2020 4,121 0 View

How to form a quasi-ominidirectional beam with antenna arrays?

For beam alignment (802.11.ad) in a mmWave MIMO system, the transmitter starts with a quasi-ominidirectional beam. My question is how to design the hybrid precoder for a quasi-ominidirectional...

11 November 2020 7,516 3 View

Is the rarity of earth metals and the refinement of the metals with harsh chemicals stalling the acceptance of electric vehicles (EV)?

Some of the metals used to build the battery pack for a hybrid car or electric vehicle can only be mined in certain areas of the world. Is this slowing down the acceptance of the vehicles? Thank...

08 November 2020 934 3 View