Composite fabrication
I fabricated Ti3C2Tx using concentrated HF 40%, I plot an XRD as attached image below.. please let to know if I obtained it or not.
02 August 2024 6,789 4 View
Dear Researchers, Is it feasible to distinguish between alpha and alpha prime martensite in the Ti6Al4V alloy under rapid solidification in the as-cast state using XRD, in addition to...
30 July 2024 3,849 0 View
I run mechanochemical reactions that involves the use of a large amount of catalyst (1:1 molar ratio to the reactant). When I try to understand the effect of amount of catalyst on the reaction, I...
23 July 2024 9,938 1 View
I work with planar interdigitated electrodes (IDEs). The finger width and the spacing between the fingers are 5 micron. The surface of the IDEs is coated by a non-conductive polymer layer...
16 July 2024 5,031 1 View
I am searching for HPLC method to estimate Mirtazapine but i want to avoid HPLC-buffers as a mobile phase component. So, I am looking for alternative HPLC-solvent (acetonitrile, methanol etc.)...
14 July 2024 1,493 3 View
I am working on powder metallurgy, and during the compaction process, the powder does not pelletize and remains in its powder form. To address this issue, I am considering using binders to improve...
13 July 2024 9,003 2 View
could Nd (Neodimyum) doping into TiO2 because Nd's dense diameters are bigger than in TiO2
11 July 2024 2,350 2 View
I am trying to load curcumin emulsion in 4% chitosan gel but i don not know how many mg powder is needed ?
10 July 2024 2,462 1 View
Dear all, l need to help me to determine pore diameter. I got from BJH data the rp(peak area), Desorption Isotherm was 1.6 nm, but from Isotherm l got type lV with hysteresis H2 loop. Can l used...
10 July 2024 2,872 1 View
I have to compare the FTIR of the two samples, one is in powder form and other one is the powder dispersed in IPA or water. Both are same material, so how the bond will change
09 July 2024 8,011 2 View