I want to study the dynamic behavior of a complex power system, including some HVDC links. In which simulation software can I study this?
Hi Dear Mohammad
I think DIgSILENT PowerFactory (14.1.3) is the best for your simulation
Currently I am using Matlab simulink association with SimPow system and DigSilent Power factory.
besides Matlab, the PSCAD a good option for simulating HVDC, for instance, with better transmission line models.
Pscad/emtdc
For simulation of part head end - DC line - head end is Simplorer ideal.
If you want to see whole process and transient in HVDC system, PSCAD/EMTDC is the best choice. You can make your own user defined model through Fortran and C and This process has already been verified many HVDC system.
For simulation of part head end - DC line - head end is also Portunus ideal.
Yet another vote for PSCAD/EMTDC here. This is _the_ tool that all the major HVDC manufacturers are using for most transient studies in real projects.
PSCAD/EMTDC.
dear all
thank you for your ans
Dear Mohammad
you can try MATLAB, PSCAD, EMTP-rv, Neplan
good luck
Could you recommend some articles on Urban Transportation System optimization and Innovation?
13 August 2024 2,595 3 View
I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?
11 August 2024 3,115 1 View
Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...
11 August 2024 8,141 3 View
I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...
10 August 2024 4,005 2 View
Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...
10 August 2024 6,493 1 View
Usually, additive manufacturing techniques like SEBM, SLS, and SLM are used for interconnected porous lattice structure generation with sizes of >100–200 micrometers. Can the Fused Deposition...
09 August 2024 7,892 0 View
I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...
09 August 2024 5,048 2 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 719 0 View
The stability of the Solar System is a complex subject that blends the classical framework of Newtonian mechanics with the modern insights provided by General Relativity (GR). Understanding this...
07 August 2024 2,569 1 View
Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.
07 August 2024 8,782 3 View