Which is the peak corresponding to glass transition temperature in the DSC graph endo up?

out of the endothermic peaks which is the glass transition temperature

02 March 2019 6,975 9 View

I did DSC calorimetry of solid sample. dsc endo up. But another up peak is observed before melting peak(at correct melting point) why two up peaks ?

What is the phenomenon behind the peak at 410K?Please help me

06 July 2018 6,708 1 View

I did DSC calorimetry of solid sample. dsc endo up. But another up peak is observed before melting peak(at correct melting point) why two up peaks ?

irn the figure given actual melting point is 423k but I am getting melting peak in this temperature aswell as a peak lower than this temperature..what phenomenon does the up peak below melting point

06 July 2018 8,744 1 View

Looking for Materials with high thermal expansion coefficient and high temperature resistance?

03 March 2021 8,272 1 View

What is your perception on using visual analysis or quantitative approaches to evaluate data from single-case research designs (n of 1 trials)?

Results of single-case research designs (i.e., n-of-1 trials) are often evaluated by visually inspecting the time-series graph and computing quantitative indices. A question our research team is...

03 March 2021 687 1 View

How two melting peaks in DSC of polypropylene can be merged into one crystallization peak?

The figure shows DSC cooling (blue) and 2nd heating (green) curves (step: 10 K/min) for a commercial sample supplied as Atactic Polypropylene (APP). The heating curve illustrates two major...

03 March 2021 5,857 3 View

Research on Supply Chain Management in Indian context?

Hi, I am planning to apply for the PhD degree in the Supply Chain Mgt. with specific area of "Cold Storage warehouses" during Pandemics and wars. Where lock downs and shut downs are frequent....

02 March 2021 285 2 View

What thickness need for ITO to use as conductive layer?

I want to do RF sputtering of ITO on glass substrate using magnetron sputtering. what thickness do i need to make it good conductive layer to use it for PSC. Moreover, whats about thickness of...

01 March 2021 395 3 View

Issues with Permeabilization during Flow Cytometry?

Hello Everyone. Currently I am working to characterize macrophages in the myocardium after ischemia-reperfusion injury in rats. Due to the low total cell number isolated from rat hearts I can...

01 March 2021 3,867 3 View

Glass fiber content in a gypsum board ?

Any idea on how to get the volumic ratio of glass fiber in a gypsum board ? Thank you for your help !

01 March 2021 2,501 3 View

What do I do with DLS peaks that are from the buffer?

I'm looking at the aggregation of my protein sample using DLS. Unfortunately, my buffer (20mM HEPES) also results in a set of peaks. These are at approximately 1 and 1000 d.nm. The lowest peak...

01 March 2021 9,015 2 View

How can I make stacked bar graph with scatter plot?

I want to make a stacked bar graph with showing each data value as dots. I tried with graph pad prism, version 6, but could not succeed. Does anyone have tried before making such graphs?

01 March 2021 9,383 1 View

Can anyone help me with the administration of the "Mind the Gap" Scale for satisfaction with transition to adult care?

We are working on a study focused on adolescents' transition to adult care and are looking for a validated measure for satisfaction with the transition. So far the only measure that we have came...

28 February 2021 2,338 1 View