I am looking for a (preferably not too expensive) device which is able to measure skin temperature (perhaps combined with heart rate) under extreme conditions (-160).
What is a good device and which things do I need to consider?
I suggest cryogenic or high/low temperature sensors, such as NeuLog or Lakeshore.
Ali Nematollahzadeh I think they are good for ambient temperatures, but for skin temperature, I am looking more for something like a patch...
Thanks for the help!
Air moisture harvesting Air water collection devices
06 August 2024 5,473 2 View
What types of mask designs for metal deposition, to be used in a PVD system, are best suited for perovskite-based solar cells?
31 July 2024 4,835 3 View
When testing devices based on ITO/ZnO/CsPbBr3/TFB/MoO3/Ag structures, I found that the current density of the device always increases sharply to 1000mA/cm2 at about 3V bias, and the device does...
16 July 2024 4,291 0 View
Continuous glucose monitors (CGMs) help patients and doctors make more timely management decisions by monitoring blood glucose levels in real time. An insulin pump provides continuous insulin...
07 July 2024 7,742 0 View
Hello, I am doing some testing on lateral flow devices/materials and have run into a slight issue where I do not understand what the cause may be, but I have some ideas. General Experimental...
01 July 2024 7,960 3 View
How will 5G impact the Internet of Things (IoT) and the connectivity of various smart devices and how will 5G revolutionize the Internet of Things?
28 June 2024 431 4 View
What are the novel technological challenges presented by IoT relative to existing technological infrastructure and devices, if any and what makes them novel?
26 June 2024 5,065 4 View
How it will affect the hysterisis cycle of ferroelectric device?
17 June 2024 4,485 0 View
Is in the real the IoT Cloud scenario the number of IoT devices is usually much more prominent compared with the number of cloud providers?
10 June 2024 7,140 2 View
I've been fabricating traction force microscopy devices in glass bottom dishes, using a method that first spins a 100 micron PDMS layer, then a ~1 micron PDMS + fluorescent beads mixture layer....
09 June 2024 652 2 View