Dear Preston Guynn

Thank you for your extensive answer. How about we put less permeable material than iron? Or somehow demagnetizing our core with the same solenoid or another solenoid within the main one with AC frequency? As we have some delays during pulses we might be able to program the controller to do so between main pulses ? How is it possible to create a push pull system as described? Any idea?

Thanks alot

Hello Preston Guynn

Thank you. The system I'm talking about is a contact system which the the shaft can't get through a solenoid. Therefore I thought a bout a permanent magnet at the end of the moving part inside a cylinder and an Iron core solenoid on top of it, fixed. Well its not working due to magnetizing effect.

Now do you think with two solenoids over each other I can get a great force when pulse is generated in both of them? Do both of them need same amount of current? Do I need to have high permeability core again or not? I can program a controller to control each solenoid individually easily.

Thanks a lot

Dear Preston Guynn

Many thanks for all your help. Till now you have shared very valuable information regarding my question. I'll go ahead with prototype in the desired form factor. All your general overviews helped me to come up with the best possible way to make this project work. Now I need to simulate the effect of two separate coils with desired specs to see how much force I can generate. I'll let you know the results.

Best of luck

Tirdad