What type of data are significantly important in modelling of the liquefaction potential of soil?

Reason for growth of fungus/mould in hydrothermal liquifaction filtered product of cellulose-based materials?

Performed hydrothermal liquefaction of cellulose powder, at about 200 degrees for 10 16 hours. After simple filtration, I stored filtered product at room temperature for 4-6 days, there is the...

03 December 2020 7,327 3 View

How can we set up Hydrothermal Liquefaction using solar/microgrid for extracting biofules?

Fo the conversion of biomass to biofuels, Hydrothermal Liquefaction is chosen.But the whole operation has to be from renewable energy source including the whole process most probably by solar and...

23 November 2020 9,432 2 View

Is there any material which is rigid in normal state and liquifies when vibrated?

Is there any material which changes into liquid state when given certain vibration such as earthquake? As we know that when we vibrate saturated sand, liquefaction takes places and the sandy soil...

27 January 2020 2,464 3 View

Large drops in pore water pressure records in liquefaction simulation in FLAC?

Dear friends! I'm validating a liquefaction problem by FLAC using Finn-Byrne model. But, there is a problem. The recorded pore pressures near the boundaries have large drops while it is not...

07 August 2019 454 10 View

Large drops in pore water pressure records in liquefaction simulation in FLAC?

Dear friends! I'm validating a liquefaction problem by FLAC using Finn-Byrne model. But, there is a problem. The recorded pore pressures near the boundaries have large drops while it is not...

06 August 2019 5,610 9 View

Can PLAXIS 3D use to evaluate the liquefaction analysis?

Dear researchers, I would like to know the ability of PLAXIS 3D, which can use to evaluate the liquefaction analysis or not? If can, could you please provide me links of its relating tutorials...

25 July 2019 7,058 3 View

Can PLAXIS 3D use to evaluate the liquefaction analysis?

Dear researchers, I would like to know the ability of PLAXIS 3D, which can use to evaluate the liquefaction analysis or not? If can, could you please provide me links of its relating tutorials...

06 July 2019 1,398 4 View

How to solve the borders of a stone colum improvement when there is no space for lateral extent?

Hello, usually when a stone column improvement is to be implemented in the case of a liquefaction potencial zone, there are a number of things to check, being one of them a sufficient lateral...

04 May 2019 1,991 1 View

Do you have any research ideas on "static liquefaction" of soils?

Dear RG Users, I have gained an interest in studying static liquefaction phenomena, however, I constantly see some other terms. Are there any other names that are being used for it? Ex: flow...

03 April 2019 8,136 12 View

Do you have any research ideas on "static liquefaction" of soils?

Dear RG Users, I have gained an interest in studying static liquefaction phenomena, however, I constantly see some other terms. Are there any other names that are being used for it? Ex: flow...

31 March 2019 7,865 10 View

Shinya Inazumi

SoilWorks for FLIP/LIQCA

Walid Mekni

Hi Demessie. First, you need the Data of the soil testing. Either it is CPT: then you need the raw Data, or boreholes, you need to convert the SPT counts. You need also the groundwater level, and the seismic parameters in the geographic zone you are modeling.

Demessie Mulu Eneyew You are welcome.