What literature should I read to start understanding flow batteries?

More Nicholas Ceccon Libardi's questions See All

How could the concentration from RNA extraction is really low?

Hello everyone, currently, I'm trying to do RNA extraction from seeds of Arabidopsis. I'm using the protocol below: RNA isolation from siliques, dry seeds, and other tissues of... I use about...

17 February 2021 7,583 4 View

How do I measure Arabidopsis germination rate?

Hi there, I'm looking for a way to measure the Arabidopsis germination rate, like what media I should use to plant the seeds and what indicator I should see for germination. I'm planning to...

02 February 2021 4,785 3 View

SDS-Gel stacking gel polymerization issues?

Can anyone provide any insight as to why my Tris/Gly SDS-Gels are polymerizing slowly? This especially applies to my stacking gel (image attached) both 4% and 6%. The stacking gel wells polymerize...

24 January 2021 3,791 4 View

How to use back-trajectory analysis (HYSPLIT) to assess air parcels at breathing/monitor height?

Hi there, I'm currently monitoring air pollution in Grenada, West Indies and as part of my project I have identified four scenarios in which I would like to use a back-trajectory analysis...

27 December 2020 730 4 View

Origin of the term "transposition" used in photovoltaic performance modeling?

In PV modeling, the process of elevating GHI data to a tilted surface is often referred to as "transposition". However, strictly speaking, "transposition" in mathematics refers to rearranging a...

22 September 2020 767 3 View

Help figuring out why only lifted cells express eGFP after transduction?

I'm attempting to transduce HEK293T cells with a lentivirus expressing eGFP. I have been observing a low transduction efficiency and after a 24 h transduction the only cells expressing eGFP are...

03 September 2020 9,491 5 View

How to stimulate PBMC-derived monocytes with TLR7 and TLR8 agonists?

I'm trying to stimulate human monocytes from fresh PBMC isolations with 2ug/mL imiquimod and 2ug/mL ssRNA40. I do this in 10% FCS complete RPMI for 18-20 hours before staining and analysing CD14+...

10 August 2020 7,095 1 View

What are the independent, intensive parameters for multicomponent mixtures (and how do I determine them)?

Hi all, For different problems in gasdynamics/thermofluids, different thermodynamic inputs are most convenient for expressing and solving the problem. For example, if I have a stagnation process,...

23 June 2020 1,085 2 View

Any recommendations for a high-quality, contract basis, academic illustrator for a paper in Nature Climate Change?

We looking for a high-quality, contract basis, academic illustrator for a paper in Nature Climate Change, any recommendations? Proven track record important.

26 April 2020 7,427 8 View

What % of high impact academic journals are genuinely not-for-profit?

In 1969, the 'Inglefinger rule' was used to protect journals from potential dual publication. Now, authors wait long periods of time for their submissions to be processed (sometimes up to 6 months...

22 April 2020 2,856 3 View

How to size battery banks?

I am designing a small grid connected solar PV power-plant. As the battery's capacity is specified in Ah and demand in kWh. What is the best way to size the battery bank? I have battery price in...

28 February 2021 1,638 3 View

How to model the battery pack in PSIM or PSCAD?

Hello, I have simulated a single battery cell using Thevenin equivalent circuit. For a battery pack, I have a large number of cells connected in series and parallel connections. Is there any way...

28 February 2021 2,116 1 View

How to calculate battery consumption for IoT device?

Hi, everyone I'm working on a privacy-preserving algorithm that will apply to IoT devices. So, I need to measure the power consumption by implementing this algorithm. Any suggestion, advice,...

25 February 2021 8,749 6 View

How to delaminate copper in water-based anodes?

Hello everyone, I'm looking for a way to delaminate copper current collector of water-based anodes in Li-ion batteries without damaging the graphite film. I tried different materials such as HNO3...

24 February 2021 3,785 3 View

What is the difference between AC conductivity and DC conductivity? Is AC conductivity = ionic and DC conductivity = electronic?

I am reading papers on batteries and although mostly people have reported ionic conductivity in Scm-1 but some have reported DC conductivity as well I and am confused as to what that is. Any help...

21 February 2021 9,207 6 View

Where can the fault diagnosis data set of lithium battery be found?

Most of the data sets on the network only contain good information about the voltage and internal resistance of lithium batteries. The data of faulty battery is missing. Who can help me, I will be...

21 February 2021 8,659 1 View

Not able to charge-discharge Li-ion coin cell at higher C rate ?

I am working on cathode material. I have made different Li-ion coin cell against Li metal using commercial available cathode materials such as LCO,LMO, LFP and NMC and also with the lab...

18 February 2021 1,450 3 View

Is there a paper that shows the effect of the thermal conductivity of solid electrolytes on lithium secondary batteries?

I want to know the effect of thermal conductivity characteristics of solid electrolytes on the all-solid battery, but I don't know which paper to refer to. Is there a paper on thermal behavior?

15 February 2021 8,806 2 View

Where would? can? positive charge(vacancy) be when grounded?

Hello I plasma(H2N2) treated Al2O3 plate (edge is connected to ground) and wondered if oxygen vacancy migration on the plate can occurs as electrons escape through edge. Or whatever positive...

15 February 2021 8,118 1 View

Why the battery connected on the load side for storing purpose is taking the volatge /current at whatever rating it is given in matlab simulation?

I am designing a DAB DC DC Converter and when I am connecting a battery block in Matlab and fix its specification lets say 350 V and 25 A, when I am giving input as 600V, Battery would charge to...

11 February 2021 3,110 1 View

Brian Shanahan

For information on all aspects of redox flow batteries and to get accustomed to the technology, the book Redox Flow Batteries: Fundamentals and Applications in good ( https://www.routledge.com/Redox-Flow-Batteries-Fundamentals-and-Applications-1st-Edition/Zhang-Li-Zhang/p/book/9781498753944)

Atef Zekri

Please check Redox Flow Batteries:Fundamentals and applications is a good start to understand the basics.

Nicholas Ceccon Libardi

Thank you, Atef Zekri and Brian Shanahan