What is the recipe of V2A-Etches?

11 November 2017 0 8K Report

After annealing treatment of Austenitic stainless steel, what kind of reagent conrotion test the sigma- phases .

Badges
Science topic

How can I apply boundary conditions in an orthotropic steel deck numerical model using ABAQUS software?

I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...

08 August 2024 719 0 View

How to fix errors in my heat transfer steel structure with reinforced concrete slab model Abaqus?

I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...

07 August 2024 1,028 0 View

Can I multiplex a mouse monoclonal and rat primary for IHC (mouse brain tissue)?

Hi all, I was just wondering if anyone has experience with multiplexing a mouse monoclonal primary and a rat primary. I'm trying to multiplex by incubating them in the same well but was told by a...

06 August 2024 9,710 1 View

Interested in a SCOPUS collaboration?

Hi RG family. My team and I are working on some SCOPUS publications and we need co-authors who are willing and capable of undertaking both qualitative and quantitative-based studies. The scope...

02 August 2024 7,843 0 View

Interested in a SCOPUS collaboration?

Hi RG family. My team and I are working on some SCOPUS publications and we need co-authors who are willing and capable of undertaking both qualitative and quantitative-based studies. The scope of...

02 August 2024 8,572 0 View

Does anyone have issues using Prepman Ultra reagent for MicroSeq ID bacterial, fungal and yeast sample preparation?

I have been attempting to extract DNA from Bacterial, Fungal and Yeast banked samples (>1e7 cells) using Prepman Ultra reagent and I seem to be struggling to obtain a sequence. Although the...

01 August 2024 2,079 0 View

What should be the sample container for the hydrothermal reaction in a microwave reactor at 180 °C for 10 min at the heating rate of 5 °C per minute?

Suggest one of them 1. Teflon-lined stainless steel autoclave: 2. Alumina (Al2O3) ceramic container

30 July 2024 7,326 1 View

Addition of EDTA during the synthesis of copper nanoparticles to prevent it from being oxidized?

I've attempted to use this method to synthesize copper nanoparticles. Copper nanoparticles can be synthesised using a variety of precursor materials. CuSO4, distilled water, NaOH, and EDTA are...

28 July 2024 8,027 3 View

Will the catalytic effect of retained austenite happens in steels including RA?

The catalytic effect of retained austenite refers to the phenomenon wherein quenching steels with a small amount of retained austenite, when subjected to tempering at a specific temperature...

27 July 2024 8,508 0 View

Please investigate the effect of temperature and strain rate of hot deformation and the formation of delta ferrite in martensitic stainless steel 410?

25 July 2024 9,408 0 View