The UV-Vis absorption coefficient of PANi nano fibers dispersed in water is very low. What are the possible reasons behind this low value?
Absorption in solution is dependent on concentration, so increasing the concentration will increase the absorption.
The peaks at~4.2 eV, 5eV and 6eV are already saturated, however, your HOMO-LUMO looks like it is at 2.3 eV or even lower.
This is may be due to the need to balance stress at grain boundaries, and satisfy constraints on the strain tensor (for example a tensile stress along one direction must be balanced by a...
07 August 2015 1,998 8 View
If we treat the problem mathematically, then 10/100 = 1/10 but if we want to make a decision related to life, what would we choose?
07 August 2015 8,823 1 View
The reported values of energy gap of CZTS thin films are in the range 1.4-1.5 eV, however, my spray pyrolysis deposited CZTS thin films have more than 2 eV energy gap. What are the possible...
05 June 2015 5,848 9 View
In Classical gas, why the most probable energy of molecule is not the energy of a molecule moving at the most probable speed?
03 April 2015 7,917 2 View
K2SO4 crystal is transparent color. The Cu doped K2SO4 crystal has light blue color. What is the exact mechanism behind this phenomenon?
01 February 2015 3,087 2 View
Do I need 1 or two clean glass substrates to perform the baseline scan for my thin film?
01 February 2015 1,312 14 View
The photon CAN transfer part of its energy to the electron and continue to exist. An example of this is Compton scattering, where a gamma ray transfers enough energy to the electron to ionize and...
11 December 2014 2,429 6 View
The thin film solar cell is either n-i-p or p-i-n
11 December 2014 8,165 4 View
And how can we measure each one of them?
11 December 2014 5,485 8 View
A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...
11 August 2024 9,801 2 View
Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!
11 August 2024 3,770 4 View
I tried four trials of the same Copper Phosphides sample in Alkaline medium ( 0.5M KOH) with Hg/HgO reference electrode and Pt as counter electrode. I used 0.001 V/s scan rate for first three...
10 August 2024 3,629 1 View
We have observed that tube to tube sheet joint leaked in our boiler and needs to overcome same by knowing the root cause.
08 August 2024 3,161 0 View
Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?
06 August 2024 980 5 View
Hi, i would like to simulate an absorption process in Aspen Plus. I want to use the NRTL model und would like to add some individual Henry coefficients. Is that possible and how?
05 August 2024 2,333 2 View
Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...
05 August 2024 3,783 2 View
Is anyone here using the Thermo Fisher Nano Orange kit for protein quantification, and detecting the fluorescent signal on the Promega Quantus? We are struggling to make sense of the standard...
05 August 2024 8,946 3 View
Why is TLC not a form of partition chromatography and paper chromatography not a form of absorption chromatography?
03 August 2024 7,035 3 View
All plants are green but some of these plants becomes yellow. I did not found any reason. Please help me to find out the real problem.
01 August 2024 589 4 View