What is the most efficient method in fabricating the PMMA, Bi, and BaTiO3 nanocomposites powders?

18 November 2024 0 3K Report

Hi and good day experts/Prof./Dr.

Can we just proceed the fabrication of PMMA, Bi, and BaTiO3 NPs powders using Ultrasonication process?

What is the most efficient method to use to fabricate the combination of PMMA, bismuth and BaTiO3?

Badges
Science topic

Mechanochemistry: ball to powder mass or ball to powder volume?

I run mechanochemical reactions that involves the use of a large amount of catalyst (1:1 molar ratio to the reactant). When I try to understand the effect of amount of catalyst on the reaction, I...

23 July 2024 9,938 1 View

How to resolve ‘[ atomtypes ] Invalid order for directive atomtypes’ error in Gromacs?

I have been using Gromacs 2021.7. I wanted to simulate two small molecules in water. But, while generating the ions.tpr, I am getting the following error. The topol.top and .itp files for each...

17 July 2024 9,897 4 View

I want to plot calibration curve of pure mirtazapine powder using HPLC. Can someone please suggest a method without HPLC buffer as a mobile phase?

I am searching for HPLC method to estimate Mirtazapine but i want to avoid HPLC-buffers as a mobile phase component. So, I am looking for alternative HPLC-solvent (acetonitrile, methanol etc.)...

14 July 2024 1,493 3 View

What binders suggestion that I can use for zinc alloy?

I am working on powder metallurgy, and during the compaction process, the powder does not pelletize and remains in its powder form. To address this issue, I am considering using binders to improve...

13 July 2024 9,003 2 View

How i figuer out the weight of curcumin powder?

I am trying to load curcumin emulsion in 4% chitosan gel but i don not know how many mg powder is needed ?

10 July 2024 2,462 1 View

Can anyone suggest what amount of powder I have to disperse in the solvent for taking the FTIR spectra?

I have to compare the FTIR of the two samples, one is in powder form and other one is the powder dispersed in IPA or water. Both are same material, so how the bond will change

09 July 2024 8,011 2 View

Is VSM measurment of NdFeB alloy powder sample require any spesific sample preparation ?

Is any specific sample preparation required to perform VSM measurement of NdFeB alloy powder to get a square-shaped M-H loop? Or is it mandatory to make magnetically aligned and sintered pellets...

09 July 2024 1,969 0 View

I have need a LPBF/SLM model on comsol multiphysics ?

In this model clearly understanding how to active one layer to another layer and how to add powder material properties step by step.

08 July 2024 6,147 0 View

Good evening, I would like to evaluate the heavy metal content in bird feathers. Can I keep my samples in powder form ?

Good evening, I would like to evaluate the heavy metal content in bird feathers. Can I keep my samples in powder form ? and can I use other tubes than Teflon for digestion?

04 July 2024 158 4 View

How do I make a solution from fibroblast growth factor since it is available as a powder?

I am using fibroblast growth factor, purchased in powder form. What suitable substance should be added to get it in a liquid form? Thanks

03 July 2024 9,866 2 View