for the parabolic silar collector how to calculate the magnitude of the total heat flux on the receiveR.
This type of collector only absorbed direct solar radiation. For calculation , it depends on the type . Vacuum pipe?.....
Regards
M.A.Ehyaei
Dear Mahdi Thanks for ur answer
Hello here i would like to discuss the difference between the academic engineering teaching and the technical engineering teaching?
31 December 2016 2,403 0 View
nano-lubricant
03 April 2016 7,549 1 View
The Nu number for a nanofluid increases based on the increase of the heat transfer coefficient. At the same time, the thermal conductivity of the nanofluids were highly increased.
02 March 2014 842 6 View
The heat transfer coefficient is a very important parameter during the thermal application, and depends on many parameter such as the materials of fluid temperature. But the other important group...
01 February 2014 5,575 18 View
There are many statistical software can use to find the nonlinear correlation for any data. I was use the minitap and spss but the equation form still not wide as I want.
31 December 2013 8,713 14 View
In the laminar flow in the constant heat wall pipe the fully developed Nu magnitude is 4.36, then is the average Nu still same or different in magnitude?
11 December 2013 3,204 9 View
I try to study the performance of engine oil pan, i would like to knew the factors that effected the oil pan performance such as oil type heat transfer properties and others?
01 January 1970 5,829 2 View
The stability of the Solar System is a complex subject that blends the classical framework of Newtonian mechanics with the modern insights provided by General Relativity (GR). Understanding this...
07 August 2024 2,569 1 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...
06 August 2024 1,989 3 View
is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it
06 August 2024 947 1 View
Hello, everyone. I have tried to determine carrier motilities of some materials, by Density Functional Theory, using Quantum ESPRESSO. There are a few methods to do it, like a package called...
04 August 2024 8,894 1 View
I want to Estimate surface heat fluxes using MyLake, but I don't have all the initial values in model parameters section and other sections,is there a way?
04 August 2024 1,537 1 View
For a grid connected BESS (lets say 100 MW/200 MWh system, LFP battery), if we charge the BESS in such a way that whenever we can access power from the solar that will charge the BESS. Hence it...
01 August 2024 9,903 7 View
What types of mask designs for metal deposition, to be used in a PVD system, are best suited for perovskite-based solar cells?
31 July 2024 4,835 3 View
We are working on a robot that cleans solar panels using fresh water supply and a rotating brush. We are trying to conserve as much water at possible by recycling the dirty water that is collected...
28 July 2024 5,778 2 View
A computational study of heat flux on cylindrical surfaces using CNT hybrid nanofluids
28 July 2024 4,985 1 View