Does anybody know a way to calculate J-integral in ANSYS APDL code or MATLAB code?

Hi, How to calculate j integral using the domain integral method in ANSYS code or MATLAB code?

04 February 2021 7,330 3 View

What is the chemical mechanism that allows the solvent N, N Dimethylformamide to dissolve the epoxy resin?

24 September 2020 8,588 3 View

How to choose from which layer to start unfreezing pretrained model?

I'm wondering how you decide on the part of the model to unfreeze. Do you do multiple experiments? Since the use of GPU is expensive, you must have some guidelines. Note: I know the relationship...

09 January 2020 8,069 4 View

DNA extraxtion with SDS/PK/CTAB?

Iwill be so grateful if any researecher can share me protocol of DNA extraxtion using SDS/PK/CTAB method . thanks

29 August 2019 2,025 3 View

How to predict the velocity distribution of a sprayed powder from a nozzle?

Hello everyone, I am searching if it exists any formula used for predicting a velocity distribution of injected solid particles in my case I used flour and the type of injection is through a...

12 June 2019 6,147 3 View

Which flow should I choose in the case of two parallel plates ?

Hello everyone, I am a little confused into choosing the right flow's nature wether it is Laminar or Turbulent and in my case I have the Fluid flow and particles are moving through two parallel...

03 February 2018 5,865 7 View

Does the term of Dynamic Viscosity exist for solid materials?

Hi there everyone ^^, I need some help for my study in the field of Fluid flow, I use COMSOL Multiphysics for this and When I add some solid materials like copper or aluminium for the geometries...

15 December 2016 3,259 15 View

Kindly tell me please what kind of plastic that resists in acetonitrile solvent?

01 December 2016 1,226 6 View

How to simulate Laminar Flow 2D between two horizontal infinite parallel plates ?

19 August 2016 5,872 12 View

Can anyone tell me what is this insect?

I had found on the hare in humid region.

19 March 2015 7,201 21 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

Small displacement measurement in vacuum?

Hello, I have a question. there is a circular thin foil which vibrates in vacuum, the foil restricted and moves up and down. it is like a diaphragm between two pipes . both sides are in vacuum but...

18 February 2021 8,075 3 View

Can I measure absorbance efficiency with wavelength in a spectrophotometer?

I measure the wavelength of material in a spectrophotometer and it peaks at 275 and its absorbance is 100. I mix it with an adsorbent and it adsorbs the first material, but when I measure the...

16 February 2021 7,515 5 View

CAT assay in microplate?

I'd like to know if anyone can provide me with a protocol for traditional catalase enzymatic assay in a 96 well microplate, for cell line and/or C.elegans spectrophotometric measurements. Thanks!

11 February 2021 7,273 3 View

How can I quantify the color of a solution?

I know colorimetry has been the standard way by way of measuring the concentration of a particular compound (solute) in a colored solution (solvent or measure quantities of a particular compound...

08 February 2021 2,673 1 View

Bradford assay for insulin: discrepancies between standard curve and sample concentration during crystallisation?

Hi there, I would like to determine the unknown concentration of human insulin in my sample during crystallisation (the concentration range is roughly 0.5 -2 mg/ml, whereas the initial...

06 February 2021 9,370 7 View

RNA concentration: Nanodrop vs Agilent 2100 Bioanalyzer?

Hi guys. I make RNA by in vitro transcription and do cell transfection afterwards. I analyze RNA using Nanodrop and Bioanalyzer. But I found the concentration of RNA measured by these two machines...

05 February 2021 292 3 View

What dilution do I use for my GNP solution UV-Vis and DLS characterization?

I have prepared gold nanoparticles using the citrate reduction method in the lab. I need to characterize them using UV-Vis and DLS, by how much should I dilute my sample for using it in the...

26 January 2021 530 5 View

Please I need MATLAB code for dynamic vibration analysis of piezoFGM plate finite element modeling?

Dear all I need some help; I am working on dynamic vibration analysis of FGM plate with piezoelectric patch using finite element modeling using MATLAB using finite element modeling

23 January 2021 3,946 3 View

How to calculate DNA concentration of a sample with high concentration buffer?

I want to calculate the concentration of DNA in an unknown sample. But it's buffer has a high concentration and our nanodrop don't accept that as a blank of dsDNA. Thus I dilute the buffer with...

23 January 2021 9,440 2 View