What is the density of BMIM[PF6] at 30 c and 10 bar?

More Mohd Belal Haider's questions See All

Algorithm used in aspen plus?

Dear All, Is it possible to know which algorithm/steps aspen plus is using for simulation. For example is it possible to see the formulas,algorithm and steps aspen plus is using to find out...

04 May 2019 10,160 5 View

How to ensure that Binary interaction parameter is correct?

I am using peng-robinson method for prediction of VLE. How to increase the goodness of fit? Is it by just giving initial values of binary interaction parameter and checking the standard deviation?? A

07 August 2018 9,854 3 View

Aspen plus file is not opening ? It reads unknown file format. Any Help?

I was doing simulation on aspen plus v8.6 . When again I am trying to open the file it reads unknown file format. I am not able to open the file . Any help is highly appreciated. Picture is also...

08 September 2017 2,381 0 View

Thermogravimetric analyzer and gravimetric analyzer !!! what is the difference between two?

what is the difference between two analyzer. beside their operation, did single instrument perform both kind of analysis. Is it possible to use same instrument for gas sorption as well as for...

08 September 2015 1,237 0 View

Problem in aspen plus simulation?

Hi, i have a problem relating with the aspen plus . i want simulate the fertilizer plant using aspen plus .is it possible to use two or more then two thermodynamic property method in single aspen...

11 December 2014 620 3 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

What is the solvent for 8YSZ nano material?

I need to do some experiment with it in liquid form.

07 August 2024 613 3 View

Hi, please what is the best tool on Aspen plus that can help me get the best inlet temperature and pressure for cryogenic distillation?

I am trying to recover liquid CO2 from a mixture of 0.6 CO2, 0.3 N2, and 0.1 O2. My aim is to recover about 99% liquid CO2 at the bottom of the column and make sure the amount of gaseous CO2...

06 August 2024 4,611 0 View

How much Yeast should we add to fermentation media?

I have prepared a liquid broth containing Yeast (S. Cerevisiae) that i need to add from it to fermentation media of lignocellulosic hydrolysate. I need to know based on what parameters do we add...

06 August 2024 662 1 View

What is the best protocol for freezing the rat brain in preparation for protein detection by Elisa ?

What is the best way to freeze the rat brain - liquid nitrogen, Dry ice , isopentane - after isolation for later protein investigation by Elisa?

01 August 2024 1,722 1 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

What is the best method to detect the chemical composition of pollen ?

I have multiple small samples of grass pollen with anthers. I want to find a method to identify concentrations of proteins, lipids, and other various elements for these samples. any suggestions?

28 July 2024 5,331 1 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

What topic or subject does Production Engineering need to address more?

Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?

27 July 2024 648 3 View