What is the best way to grow monocrystalline (002) piezoelectric ZnO nanowires or nanotubes?

Is it possible to do piezoelectric coupling in ANSYS-APDL or COMSOL between tapered substrate and rectangular piezoelectric patch?

How to do Piezoelectric coupling in ANSYS-APDL or COMSOL between tapered substrate and rectangular piezoelectric patch? Piezoelectric coupling between the rectangular substrate and rectangular...

02 March 2021 9,833 3 View

Can anyone share his experience regards Smoothing in origin?

I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...

26 February 2021 8,183 3 View

What are the methods used for CNT..?

Respected Professor's i hope you are doing well and happy. i need some information about carbon Nanotubes. before blending the CNT with the matrix the CNT has been introducing in some treatments....

24 February 2021 5,383 5 View

Is nanotechnology part of materials science? Is it possible to obtain Pico technology and move from hypothesis to application?

Pico-scale This is three orders of magnitude smaller than a nanometer (and thus most nanotechnology) and two orders of magnitude smaller than most chemistry transformations and measurements. Pico...

18 February 2021 4,540 5 View

RDF calculation of water inside the Carbon nanotubes?

I am trying to calculate the rdf of water molecules present inside the Carbon nanotube. I tried to do the indexing first using gromacs tool gmx selection. But when it comes to calculating rdf, I...

17 February 2021 1,066 3 View

How to do buckling analysis in ansys apdl for laminated plate with PZT 5H attached?

I am doing buckling analysis of laminated plate surface bounded with two piezoelectric PZT 5H and axial compressive load is applied. I am getting an error, No ANEL table exists for material 2....

16 February 2021 510 1 View

Could you please suggest to me an interesting and good book about Nanotechnology?

I want to know about nanotechnology from beginning to professional. Thus I want some book in this area

01 February 2021 1,889 13 View

Which method is preferable for cutting the nanocomposites?

Which of the methods like water jet cutting, diamond cutting, laser cutting, etc. is more suitable to cut the carbon nanotubes reinforced epoxy composites into test sample to ensure the clean...

29 January 2021 1,354 5 View

Is there a faster way of removing and collecting the carbon nanotubes on the surface of the stainless steel 304 plates other than sonification?

The usual way of properly removing and collecting carbon nanotubes (CNT) is to sonicate the stainless steel plates coated with CNT under isopropyl alcohol (IPA) solution, remove the plates after...

28 January 2021 9,455 1 View

What is the maximum voltage a piezoelectric PZT layer can handle?

I have a circular PZT layer deposited by PLD method. The dimensions are: 20um diameter and 350nm thick. It has 100nm Pt electrodes sputtered on the top and bottom. I would like to know what is the...

25 January 2021 688 5 View