What is First-Three Harmonic Filter ?

More Novvria Sagita's questions See All

Steglich Esterification?

I want to make ester or amide bond using the Steglich esterification method (using dicyclohexyl carbodiimide and dimethylamino pyridine as reactant). Can it be done in aqueous solvent?

19 January 2014 5,833 13 View

What are the values needed for gabor filter's parameter for cifar10 data?

Hi, I implemented a code to gabor filter cifar10 data but the images after being filtered and stacked are not clear like the original images. I think the problem is in the way I am using the...

03 March 2021 6,317 1 View

How to calculate Total Flavonoid?

I analyzed flavonoid total spectrophotometry, the procedure as below: 2 ml supernatan added 5 ml dd.H2O, then added 0,15 ml NaNO2 5%, 5 minutes later added 0,15 ml AlCl3 10%, After 6 minutes,...

01 March 2021 6,722 1 View

What would be the best method to study the seasonal variation in wetland vegetation?

I wanted to learn how the seasonal variation relate to climate change. The best samplimg methods are required. Therefore, any references or suggestions are welcome. Thank you

24 February 2021 8,589 3 View

RNA-seq DEGs downstream analysis and reporting in literature?

I used EdgeR to get the list of DEGs (differentially expressed genes) from my liver RNA-seq experiment. I have done the gene overrepresentation and GSEA based pathway analysis. I am currently...

23 February 2021 8,969 1 View

What are the ranges of four diffterent poles of butterworth filter for ECG signal?

Hi, Can anyone please tell me what are the ranges of four different pole orders such as first order, second order, third order and fourth order respectively of butterworth filter for ECG...

23 February 2021 2,554 3 View

Which polarizers are usually used to measure the birefringence of zebrafish muscles?

I already found several publications on that topic, however, the specifications for the used filters are often missing. Some more specific information than "fish is placed between to polarizing...

23 February 2021 1,934 1 View

What low-cut filter (high Pass frequency) to be used for response spectrum (Tripartite plots) ?

What low-cut filter (high Pass frequency) to be used for the response spectrum (Tripartite plots)? I am currently working on differentiating between hard/soft site responses in Indo-Gangetic...

21 February 2021 9,273 2 View

Is it possible, for a limited dateset of images, to use Convolution filters + Random Forest instead of UNet?

UNet is 'relatively' recent and was invented mainly to deal with biomedical images, yet is it also possible, for a limited dateset of images, to use Convolution filters + Random Forest instead of...

21 February 2021 4,858 3 View

The type of filter paper used to filter an epoxidized oil (the mixture is an epoxidized oil with magnesium sulfate) ?

I have a mixture of epoxidized oil and magnesium sulfate wich type of filtre paper should i use

21 February 2021 3,944 3 View

How to correctly choose the number of solution intervals when preforming harmonic analysis in ANSYS?

Good day, I design the rail-wheel geometry and the harmonic frequency ranges between 20-10kHz with 500Hz solution intervals and the results makes sense. Most of the time on the related literatures...

19 February 2021 3,190 3 View

Nabil Karania

There two type of filters ( passive & active ) power filter. Also each load had their harmonics shape, for example 6 bridge rectifier -3 phase have a harmonic orders as ( 6h plus minus 1)..which means this type of loads produced harmonics from the orders (5,7 ,11,13.....).

Novvria Sagita

Is it applied in signal processing data?or it also can be applied in time series data?

It's applied in singal processing data for sure....any network should studied its behavior in both domain ( time & frequency).