How plasma surface treatment is different corona discharge treatment?

01 February 2016 9,912 3 View

What is the clear cut definition of glow discharge, arc discharge, corona discharge?

I am now learning about corona treatment for my research on surface treatment. To understand the basic, i studied electrical discharge in gases. Though i understood about glow, arc and corona...

01 February 2016 832 7 View

How can I avoid wettability of PVDF membrane at high temperatures?

I have prepared PVDF membrane by NIPS method. I obtained good hydrophobicity. (When the water is dropped on the PVDF membrane it is rolling). But the membrane is soft and it is easy to tear. The...

06 July 2015 6,657 4 View

How can i avoid the shrinkage of PVDF membrane during drying process?

I am preparing PVDF membranes for desalination purpose. After preparation and during drying in air, the membrane gradually shrinks. About1/4 size get reduced from oringinal size. I coated on a...

05 June 2015 7,757 5 View

Glass fiber content in a gypsum board ?

Any idea on how to get the volumic ratio of glass fiber in a gypsum board ? Thank you for your help !

01 March 2021 2,501 3 View

Can polymer concentrations be calculated based on the number average molecular weight?

Hello, I spin-cast two different polymers onto wafers and measure their height as a function of initial concentration. For polymer A, I have the weight-average molecular weight (Mw) as well as...

28 February 2021 7,882 2 View

What is the density for pva electrospining?

I'm Juan Carlos, a high school student who is working with electropinning, I made an electropinning machine with a 21g needle and a 30kv high voltage source and the distance between my needle is...

28 February 2021 298 3 View

No title

I am trying to find how to know the density needed for a pva electrospinning in a 0.6mm neddle, the electrospinning will be from top to bottom and the problem I really have is the solution because...

25 February 2021 2,615 3 View

How can we limit artifacts caused by rotation in fiber photometry?

We are trying to run fiber photometry experiments for long time scales, but we get these sinusoidal artifacts that come up. We think they may be caused by twisting of the fiber optic subject...

25 February 2021 568 1 View

How to properly calculate Interfacial area density in a porous domain?which are possible value for glass fiber?

I'm doing a cfx simulation of a multiphase flow in pultrusion and i set the Interfacial Area density in the heat exchange of a porous medium in this way IAD=Total fiber lateral surface of fiber...

23 February 2021 6,043 1 View

How can we add reinforced thermoplastics with granules in injection molding machine?

I need to make an injection molding machine in which short fibers are to be introduced. Short fiber length and material properties are to be determined and also the material strength are to be...

22 February 2021 4,290 1 View

Staining methods for skeletal muscle fiber typing?

does anyone know the best method to differentiate and quantify rapid fatiguing and fatigue resistant muscle fibers? the old method form the 1980's uses ATP staining which is quite labor intense?

21 February 2021 6,483 3 View

Onset of Photo Oxidation in Polymers?

Hi! I am looking for some specific information in regards to the minimum amount of UV intensity required to begin the photo degradation process in polymers. I understand each polymer is...

15 February 2021 7,703 4 View

Gromacs force field and water model recommended for protein hydrophobic study?

Dear All, I received a comment from reviewer about asking me selection of force field and water model. I choose OPLS-AAL and 3-point water model. They mentioned the combination of OPLS-AAL and SPC...

13 February 2021 1,364 3 View