01 January 1970 8 6K Report

I am starting on wireless sensor networks so I came across this simulator called Network Simulator 3 (NS3) but I find it hard to begin with as I am just starting working on WSN.

Are there any other simulators which provide easier implementation of WSN or provide implementation actual WSN motes i.e TelosB MICAz IRIS etc ?

Thanks in advance.

More Zia Askari's questions See All
Does synchronization issue occur in data prediction for data reduction in WSN using least mean square algorithm ?

I have made a setup of two nodes using Arduino and a wireless communication module. Both nodes run the same algorithm and predicts the next sample after each iteration. As in standalone mode...

04 May 2019 6,479 2 View

How do I program wireless sensor network (WSN) motes like MICAz?

I have worked on Arduino and Raspberry Pi. I saw that the WSN motes have Atmel microcontroller, can I program on it and what language is used for programming?

31 December 2018 7,664 3 View

Tutorial for Tiny OS needed.

I am starting to make an application on wireless sensor network motes i.e. IRIS motes , I saw that I should use TinyOS for creating "exe" file which is then loaded to IRIS mote via MoteConfig...

01 January 1970 4,104 1 View

Can we run DSP algorithms on Wireless Sensor Network (WSN) motes like IRIS ?

I am starting my project in WSN by implementing DSP algorithms in actual WSN motes. How to check whether the hardware is capable of running a simple algorithm as convolution.

01 January 1970 4,042 3 View

Which operating system is sutiable to make an application on IRIS mote , Tiny OS or Contiki OS?

I read that Tiny OS uses nesC language to build an application whereas Contiki OS uses C-language. I am just starting to make a project utilizing IRIS motes and my application require multiple...

01 January 1970 2,647 5 View

Similar questions and discussions
How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

How to improve and implement WBAN MAC and Radio modules under Castalia 3.2 ?

Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...

28 February 2021 400 1 View

What are the patterns of human behavior that lead to COVID-19 infections?

Does data from contact tracing help in establishing patterns of behavior and social interactions that lead to infections? There are cases here in the Philippines where patients have no travel...

25 February 2021 9,002 13 View

D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View

Is it possible to set a breakpoint at a specific DYNAMIC instruction using the GNU Debugger (GDB)?

Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...

24 February 2021 1,598 2 View

Langevin Dynamics in shear flow?

Hi, We are trying to simulate particles with Langevin dynamics in a shear flow by Lees-Edwards boundary conditions in MD simulations. It seems thermal forces and shear flow do not go hand in...

23 February 2021 1,761 1 View

Should I use Pressure Based Solver or a Density-Based Solver?

Dear researchers, I want to simulate a flow (air) in a wind tunnel, and I want to integrate a fluidic actuator inside it in order to control the separation of the boundary layer. At the blower...

22 February 2021 4,882 3 View

Are there any databases for gene co-expression or expression pattern clustering?

I am currently working on gene clustering based on co-expression pattern in mouse brain. The problem is I do not have some solid way to test my result. Are there any suggestions for databases...

22 February 2021 4,374 3 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close