Does synchronization issue occur in data prediction for data reduction in WSN using least mean square algorithm ?

I have made a setup of two nodes using Arduino and a wireless communication module. Both nodes run the same algorithm and predicts the next sample after each iteration. As in standalone mode...

04 May 2019 6,479 2 View

What are wireless sensor network simulators for beginners?

I am starting on wireless sensor networks so I came across this simulator called Network Simulator 3 (NS3) but I find it hard to begin with as I am just starting working on WSN. Are there any...

01 January 1970 5,877 8 View

Tutorial for Tiny OS needed.

I am starting to make an application on wireless sensor network motes i.e. IRIS motes , I saw that I should use TinyOS for creating "exe" file which is then loaded to IRIS mote via MoteConfig...

01 January 1970 4,104 1 View

Can we run DSP algorithms on Wireless Sensor Network (WSN) motes like IRIS ?

I am starting my project in WSN by implementing DSP algorithms in actual WSN motes. How to check whether the hardware is capable of running a simple algorithm as convolution.

01 January 1970 4,042 3 View

Which operating system is sutiable to make an application on IRIS mote , Tiny OS or Contiki OS?

I read that Tiny OS uses nesC language to build an application whereas Contiki OS uses C-language. I am just starting to make a project utilizing IRIS motes and my application require multiple...

01 January 1970 2,647 5 View

What is the most Operating System (OS) which can be INSTALL on Tiny hard devices like Raspberry Pi (RPi) hardware ?

I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...

03 March 2021 1,931 5 View

How do you write a simplified C block code of this average-current control on PSIM?

This is a Buck (step-down) Converter and I am new to this program. I need to program with simplified C block and I actually don't know what to do. Can anyone show me how to do this? Or at least...

02 March 2021 8,233 1 View

Do you know good and user-friendly programs to measure plant quantitative traits?

For my research i will need to measure plant quantitative traits (especially leaves area and roots length, but would be nice to add some more information). I recently discovered...

01 March 2021 5,035 2 View

How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

How to improve and implement WBAN MAC and Radio modules under Castalia 3.2 ?

Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...

28 February 2021 400 1 View

What are the patterns of human behavior that lead to COVID-19 infections?

Does data from contact tracing help in establishing patterns of behavior and social interactions that lead to infections? There are cases here in the Philippines where patients have no travel...

25 February 2021 9,002 13 View

Is it possible to set a breakpoint at a specific DYNAMIC instruction using the GNU Debugger (GDB)?

Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...

24 February 2021 1,598 2 View

Implementation of chance-constrained optimization problem via scenario approach?

23 February 2021 7,826 2 View

I am looking for a simple software program to model 3D chemical bonds. The purpose is to generate high-quality graphical abstracts. Any suggestion?

Hello everyone: I am looking for a simple software program to model chemical bonds. The purpose is to generate a high-quality graphical abstract for a top leading journal in the field of...

23 February 2021 8,012 3 View