Nil
Which tools can be used to generate machine codes for additive manufacturing?
02 March 2021 7,220 2 View
I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....
24 February 2021 4,428 3 View
Most of the references I found were on the economic productivity in agriculture but very limited application in manufacturing sector. I would appreciate if anyone could share the references on...
15 February 2021 8,342 7 View
I would highly appreciate it if my fellow ecologists (biologists) provide their opinion on the thoughts below [esp., shortly tell us which path may be more effective, if they know another way, if...
15 February 2021 3,642 6 View
Hi I am conducting an interobserver variability study where we have 12 raters who are going to rate samples of lesions. They will rate up to 10 variables per sample. Although the size of the...
12 February 2021 7,276 3 View
I'm working on my dissertation and it is about how to save energy when a CNC machine goes to idle mode. (A concept model of the idle machine energy saving in industrial manufacturing...
26 January 2021 9,620 5 View
I have tried to use TTC agar overlay method for a few times to identify respiratory-deficient yeast which were affected by EthBr. The problem is that cells which should have stayed white also have...
22 January 2021 585 10 View
Ansys 19.2 R2 and 2020 R1 versions of Additive Manufacturing Workbench is convenient for powder-based Additive Manufacturing processing. However, in this workbench, there is a machine parameter...
19 January 2021 3,017 2 View
I will be guest editing a Special Issue "Climate Variability Impacts on the Energy System". The Special Issue covers issues relating to climate variability and change (CV&C) impact on the...
01 January 2021 3,059 1 View
Dear Research Gate Members, Nowadays, everyone is talking about the new variant of Corona virus COVID-19 and its affects are alarming throughout the world. Please, share your expert suggestions...
29 December 2020 7,555 20 View
