What are the most common pitfalls/difficulties we encounter when analyzing EIS test results?

11 November 2013 0 645 Report

Why are the electrochemical impedance spectroscopy results mostly non-producible, confusing and difficult to correspond to specific interfacial schemes in a number of common corrosion conditions?

Badges
Science topic

Similar topics
Chemistry

More Faysal F. Eliyan's questions See All

How can we study the corrosion behavior of the nonmetallic inclusions in pipeline steels?

The nonmetallic inclusions are problematic particles that develop during the steel making process. They are tiny entities that exist in high numbers. They disrupt the mechanical homogeneity of the...

31 December 2014 7,761 16 View

What verification we need on the latest BICEP2's universe inflation?

There are a few points being raised lately on the first direct evidence on the universe inflation and the detection of gravitational waves: 1. The cosmic microwave polarization patterns referred...

04 May 2014 4,140 3 View

What is so unique about the egg?

The egg is one of the unique feats of natural engineering. Its three-dimensional arch structure can support the weight of a standing human being yet it is so delicate that a baby bird can peck its...

03 April 2014 4,654 4 View

Can fracture mechanics predict when the whole Universe will fracture?

This question is open for chemists, metallurgists, physicists and astrophysicists: Check out this diagram which has been released today on Universe inflation. It describes how the universe has...

03 April 2014 329 22 View

How should the corresponding author approach a journal editorial office when the status 'With Editor' did not vaguely change for so long?

In case for example the status 'With Editor' did not change for two months or so, Are there risks of any kind the corresponding author should be aware of when reaching the journal's editorial...

02 March 2014 7,100 2 View

How does H2S affect the corrosion reactions in CO2 solutions?

Please see attached this figure from a journal paper I am currently reviewing. I made slight changes to it to maintain the anonymity. The paper addresses the significance of H2S with the...

02 March 2014 6,537 1 View

Why the rate of hydrogen generation increases with chloride concentration?

Please check out these potentiodynamic profiles for experiments I recently carried out: it shows potentiodynamic scans for a pipeline steel immersed in CO2-saturated solutions of different...

02 March 2014 3,069 13 View

Can computational fluid dynamics help calculate corrosion rates of pipelines?

I am currently reviewing a research paper presenting an electrochemical study on corrosion-enhanced erosion. It attempts to link the CFD of a modeled flow to the corrosion rates of an elbow made...

02 March 2014 4,297 5 View

On the relationship between speed and time, have the standardized tests gone too far?

Please check out this question excerpted from a standardized test for high-school students in a North American country; It says: Which of the following would be a graph of speed vs. time for the...

02 March 2014 8,400 3 View

How reliable is the potentiodynamic polarization in predicting the corrosion behavior?

To test the corrosion behavior (or resistance) of an engineering material in an aqueous medium one can carry out immersion tests for specific periods of time across which the mass loss and...

02 March 2014 4,690 11 View

How to calculate CCS for Sodiated adduct ions and Multiply Charged Ions?

I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...

08 August 2024 8,329 0 View

What procedure should I follow for current controlled PPy film electrochemical deposition on ITO?

For example, I perform passivation process before electropolymerization of Py for adhesion to titanium surface. Is a similar or different procedure required for ITO? If necessary, I would be glad...

06 August 2024 3,176 0 View

Why might the impedance values for DI water and 0.1X PBS buffer solution exhibit a decreasing and increasing trend, respectively over time (HP 4194A)?

Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...

05 August 2024 3,783 2 View

Mossbauer spectroscopy Co0.6Mn0.4Fe2O4 MNPs?

Following curve related to Co0.6Mn0.4Fe2O4 Magnetic nanoparticles with extra phase a-Fe2O3. I will appreciate to help me to interpretation this spectroscopy, especially the blue line.

31 July 2024 9,140 2 View

Inquiry on Maximum Nucleic Acid Volume for 2.5 mL Liposome Solution?

I am currently working on a project involving liposomes and need to determine the maximum volume of siRNA that can be added to a 2.5 mL liposome solution with a total lipid concentration of 10...

30 July 2024 6,420 1 View

How to calculate conductivity using Electrochemical Impedance Spectroscopy's Nyquist plot?

Hello everyone, I am new to this characterization but watching videos on youtube I have already plotted a Nyquist plot (Z' and -Z'') and already fitted models on my material using Zsim. But now I...

29 July 2024 1,376 0 View

Can I proceed with Response Surface Methodology (RSM) with only one factor for further optimization?

I went for Plackett Burman Design for selecting the optimization factors of growth conditions for pesticide degradation. I started with 7 parameters. But, after the experiments and analysis, only...

29 July 2024 5,015 1 View

I did hirshfeld surface analysis for molecule but did not find red spot and interaction surface in energy frame work, is it ok for research article ?

In hirshfeld surface calculation i did not find any red spot in hirshfeld surface, is it ok for research article to write?

28 July 2024 2,988 0 View

How can I use DFT-D3 correction ( Siesta version 5.0.1)?

Dear Siesta Users, I installed Siesta 5.0.1 and I want to use Grimme's D3 correction. According to the 5.0.1 manual, I could use a few parameters to include the D3 correction in the...

27 July 2024 5,748 0 View

Why semicircle of nyquist plot is not complete?

While I am doing HER, I noticed that nyquist plots of Electrochemical Impedance Spectroscopy (EIS) is not complete. Will it affect for the Linear Sweep Voltametry (LSV) data? However, I can found...

26 July 2024 7,542 4 View