What are the dissociation energy values of LiTFSI, LiDFOB and LiTDI salts?

More Anji Reddy Polu's questions See All

Why fast capacity decay with electrochemical cycle exist in Li/Solid polymer Electrolytes/LiFePO4?

The reversible capacity in 1st cycle is good in Li/LiFePO4 cells. What is the best explanation for fast capacity decay with increasing cycle number.

03 April 2016 2,395 1 View

How to find cumulative impact factor of all my publications?

I would like to know how to calculate cumulative factor of all my publications. Thanks.

03 April 2016 8,392 4 View

Is the reaction between OH groups of Silanol and LiOH (or) NaOH possible?

For preparing Na or Li salts, the reaction between OH groups of Silanol and LiOH (or) NaOH possible? I need to replace H in OH of Silanol by Li or Na. If possible, what are the reaction conditions?

03 April 2015 9,018 1 View

Why there is shift in the characteristic peaks of PEO on addition of lithium salt in XRD?

I observed two high intensity diffraction peaks at 19.36º and 23.72º in pure PEO, but on addition of Li salt the peaks shifted to lower 2 theta values (18.8º and 23º). Can anybody tell me the...

02 March 2015 757 3 View

How to calculate CCS for Sodiated adduct ions and Multiply Charged Ions?

I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...

08 August 2024 8,329 0 View

Inquiry on Maximum Nucleic Acid Volume for 2.5 mL Liposome Solution?

I am currently working on a project involving liposomes and need to determine the maximum volume of siRNA that can be added to a 2.5 mL liposome solution with a total lipid concentration of 10...

30 July 2024 6,420 1 View

How can I use DFT-D3 correction ( Siesta version 5.0.1)?

Dear Siesta Users, I installed Siesta 5.0.1 and I want to use Grimme's D3 correction. According to the 5.0.1 manual, I could use a few parameters to include the D3 correction in the...

27 July 2024 5,748 0 View

EDC carbodiimide and NHS easter 's half life among different pH?

It has been long known that EDC carbodiimide and NHS easter's half life agains hydrolysis are highly related to pH. However, very surprisingly, not yet found a paper giving a table/chart of their...

25 July 2024 8,738 0 View

Mechanochemistry: ball to powder mass or ball to powder volume?

I run mechanochemical reactions that involves the use of a large amount of catalyst (1:1 molar ratio to the reactant). When I try to understand the effect of amount of catalyst on the reaction, I...

23 July 2024 9,938 1 View

How to eliminate the carry-over effect in GC-MS/MS system?

Hi, I am a PhD student working at Jagiellonian University, Faculty of Chemistry. My work is related to the development of new analytical methods for the quantification of short-chain fatty acids...

22 July 2024 5,492 6 View

MDCI module in Orca software?

Dear Researchers, My question is associated with the "MDCI" method in Orca. Please let me clarify my question using a simple example: Suppose we are going to perform CBS extrapolation using "!...

21 July 2024 1,632 0 View

What does an additional peak in FTIR between 3100 and 3300 nm affect the quality of the material, benzethonium chloride USP??

I do not know much about FTIR! The material Benzethonium Chloride USP was compared to a reference standard in regards to FTIR, as per the USP testing: Identification B. Infrared absorption (FTIR),...

16 July 2024 6,918 7 View

How can I do photodetector application from Inorganic nanoparticles compound?

I have an inorganic nanoparticle compound I want to do a photodetector application from this compound, I do not have any idea, can anyone help me with this?

11 July 2024 135 1 View

What are the principles of physical chemistry?

what are the main points

10 July 2024 9,236 5 View