What are pre-defined boundary conditions for EM field at the boundary surface between two finite domains of different EM characteristics in CST?

Vladimir B Stankovic @Vladimir_Stankovic5

06 June 2018 0 3K Report

Does anyone know what are (if there are any) pre-defined boundary conditions for EM field at the boundary surface between two finite domains of different electromagnetic characteristics in CST Microwave studio?

Badges
Science topic

More Vladimir B Stankovic's questions See All

What is connection between impedance and power for discrete port in CST MW&RF?

What is connection between impedance and power for discrete port in CST MW&RF? Which power corresponds to the value of impedance of 50ohm?

31 December 2015 6,524 3 View

I have get this error when i calculated the geometrical optimization for prco3, it takes 12 hours until gives this message in the outputfile?

Fatal error in MPI_Allreduce: Other MPI error, error stack: MPI_Allreduce(1628)......: MPI_Allreduce(sbuf=000002459254A180, rbuf=000002459F86A140, count=4851, MPI_DOUBLE_COMPLEX, MPI_SUM,...

09 August 2024 7,615 1 View

Regarding LBM in Boiling?

What should be the equation for halfway bounce back boundary condition for flow field with forcing term?

08 August 2024 7,938 1 View

How can I apply boundary conditions in an orthotropic steel deck numerical model using ABAQUS software?

I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...

08 August 2024 719 0 View

How can you draw a coordinate bond between a metal and donor atom in metal complexes, using discovery studio visulizer software?

Hello,, The metal complex ligand appears incomplete in the screen of the discovery studio visualizer

30 July 2024 3,354 1 View

What should be the sample container for the hydrothermal reaction in a microwave reactor at 180 °C for 10 min at the heating rate of 5 °C per minute?

Suggest one of them 1. Teflon-lined stainless steel autoclave: 2. Alumina (Al2O3) ceramic container

30 July 2024 7,326 1 View

How to prediction 2D to 3D aptamer?

Hello, I have a little problem. Well, right now I only have the DNA aptamer sequence. I went to see the 2D model form with DNA folding. After that, I used RNA Composer to simulate in 3D and used...

30 July 2024 6,794 0 View

Why in 2D image created by discovery studio 2021, the halogens appear as alkyl group?

In my molecule there is Chloro group at 2-position of phenyl ring, but in 2D image it appears as methyl showing no interaction.

28 July 2024 734 0 View

Wrong out put for gmx x2top?

Dear users, I would like to simulate a zeolite structure in gromacs. I got the .cif file from IZA expanded in one direction in Materials Studio and exported a .pdb file. However, when I want to...

24 July 2024 367 4 View

What is the average energy consumption per gate operation with superconducting qubit?

Could you provide information on the average energy consumption per gate operation when using superconducting qubits, specifically focusing on the microwave power required to implement gates? I...

15 July 2024 954 0 View

How to introduce on fluent the optical loss of the wall due to the reflection of the plate towards the environment ?

"When solar irradiation reaches a surface, some of it is absorbed while the rest is reflected. Part of the light absorbed by the surface transforms into heat and increases the module's...

13 July 2024 8,621 5 View