i am using two 555 ic timer for generating square wave: on of 100us pulse duration and other of 800us pulse duration and then pass this two through a logic AND GATE so that can get 8 square wave 100us. means 800us is the ON period and 800us is the OFF period. I want to increase the voltage of the the square wave obtained from AND GATE output.
i am attaching the waveform.
please help me to figure it out.
Why not use IC741, op-amp and use it as an amplifier? https://en.wikipedia.org/wiki/Operational_amplifier#Voltage_amplifier
The circuit depends on the required power: If P 100 Ohm and 5000 Ohm -> 500 Ohm). The IC 741 is no solution, it is much too slow.
thank you so much for your replies but i got higher voltage (50V) with using instrumentation amplifier.
Interesting, Vikash... Would you recommend riding a bicycle, to travel to the moon?
- Badges
- Science topic
- Similar topics
- Engineering
- Telecommunications Engineering
- Antennas and Propagation