Why do the air flow results vary totally when adding scalar in CFD ?

Dear All, We are using Autodesk cfd to calculate the air flow in a single sided naturally ventilated room, where air flow depends only on buoyancy due to temperature difference between inside and...

25 February 2021 9,602 4 View

What are effects of steel jacketing on flexural strength?

Dear all, If steel jacketing is used to retrofit a reinforced-concrete (RC) column, can we use it to improve flexural strength? I understand that we leave gaps between the ends of the jacket and...

22 February 2021 1,906 5 View

How to model steel jackets using SeismoStruct?

Hi all, Does SeismoStruct support modeling rectangular RC columns retrofitted with steel jackets (e.g. rectangular, elliptical) ? Any suggestions for other software (apart from...

20 February 2021 4,521 1 View

Room Occupancy Calculation ?

15 February 2021 1,997 6 View

What Buffer should i use for T4 virus for electron microscopy ?

Hello, I currently have my T4 virus in HEPES buffer. Unfortunately, there are always crystals that are contaminating my solution (due to the buffer in which the Viruses are) when I observe them...

01 February 2021 400 3 View

Can we use control variables during Structural Equation Modeling with Amos?

We want to explore a mediating relationship employing SEM with Amos SPSS. Our independent variable is attitude toward wife abuse. mediator is exposure to male marital violence, and outcome...

07 January 2021 4,481 3 View

Response Surface Methodology?

I'm using 3 different light intensities (constant values 15,30,45 W) for the wastewater treatment of an organic compound and optimizing the parameters (pH, catalyst dose and light intensity)...

31 December 2020 2,377 4 View

How to simulate a varying load /load profile in Simulink/MATLAB?

I am looking for a block in MATLAB that can simulate a varying load such as a load of a house given below. this block will be connected to a power system

27 December 2020 5,835 5 View

Is Psychotherapy effective for children than adult? Why? Is there any good article to respond that?

I study and research about anxiety disorders in children in Iran and I sometimes face questions like this and unfortunately I could not find article or book to answer that.

30 October 2020 6,822 7 View

No title

30 October 2020 961 3 View

Standard curve shifting over time. How do I stabilise the ELISA?

24 February 2021 1,365 3 View

How does the injection volume impact LLOQ and ULOQ in regression analysis (LC-MSMS)?

Hello, I have run into an issue that has sparkled a debate at work: is the LLOQ/ULOQ impacted by injection volume under the following circumstances: 1) Same dilution factor of all samples 2)...

23 February 2021 9,159 3 View

Using the Pfaffl method: Is it possible that the ratio of the calibrator does not equal 1?

Hi all, I have a question regarding calculations using the Pfaffl method. I have 3 groups per experiment: 1 control group (calibrator) and 2 treatment groups with 6 to 7 biological repeats per...

19 February 2021 8,351 2 View

XRPD Quantification - Building a calibration curve of drug excipient?

I am aiming to utilise XRPD to quantify a drug excipient within a drug product and have been having a little trouble building the calibration curve to allow for this quantification up until this...

10 February 2021 6,145 3 View

Gain and offset values in Sentinel-2 L1C?

Hello everyone. I have been trying to apply radiometric calibration on Sentinel-2 L1C images (bands 2,3,4 and 8), but every time after layerstacking I come across this error: "Calibration...

28 January 2021 7,160 1 View

How can you confirm new liquid FTIR cell fits calibration?

We have an FTIR instrument which was calibrated in transmission/absorption mode using a set of cells for different ranges of D2O concentration. One of the cells at high range broke and the new one...

16 January 2021 4,791 2 View

Standard addition calibration without blank matrix available?

I have a problem of analytical chemistry. We are working on a spectroscopy technique (FTIR) for the quantification of a mineral phase in complex matrices. We intended to use chemometric techniques...

12 January 2021 7,739 1 View

How does the dilution of matrix-match calibrators impact the ionization in LC-MS/MS?

Greetings. I would like to get opinions from the experts for the improvement and optimization of multiple drug confirmation by LC-MS/MS. 1. One of our method calibration curves follows the...

10 January 2021 9,559 2 View

Do polymers with different chain lengths have UV-Vis absorption peaks at different wavelengths?

I have a sample of mixtures containing polystyrene microspheres (PS-MS) with 3 different diameter sizes (bought from thermo), they all contain a green fluorescent dye inside the polymer matrix /...

06 January 2021 2,218 5 View

How to develop mathematical model for Eye-Gaze tracking system?

Gaze tracking technologies are used in a wide variety of applications. Most gaze tracking systems require a personal calibration process where the user is instructed to gaze at certain points...

03 January 2021 9,675 5 View