Two parallel spark gap effect with sinusoidal voltage power supply - where can this effect be used?
Voltage is approximately 6 kV, 70 kHz.
Spark gaps are using the same high voltage power supply.
One spark gap is approximately 0,5 mm wide and the second gap is a little bit wider, about 0,7 mm wide, they are both working at the same time.
The parallel distance between spark gaps is 2 cm.
Spark gaps need to be fine-tuned very patiently to achieve that both gaps are working.
When I put material between these two gaps, then only one gap is working.
More Ivica Bevanda's questions See All
Similar questions and discussions