The higher frequency, the higher VSWR ?

30 October 2023 1 795 Report

I have found that antennas tend to have higher VSWR as the resonant frequency increases. (The operating frequency range is low??? Impedance matching is more difficult??)

I wonder if this trend is true.

thank you

张卓 Zhang

yes

Badges
Science topic

More Jong-Mine Lee's questions See All

Why did the resonant frequency of my six fabricated antennas go up?

I made the patch antenna with 8 via holes and 1 hole to feed, and it operates at 5.8 GHz. And I suspended the superstrate, which has PRS(Partially reflective Surface), to make a Fabry-Perot cavity...

23 November 2020 3,965 3 View

What is the difference between the via hole and the shorting pin on the microstrip antenna?

I want to know about the difference. Could you give me an answer or a suggestion? Recommended any paper on this topic is okay. Thank you.

15 March 2020 2,860 2 View

How are iso-frequency contours plotted?

Let's say we have a standard, regular hexagonal honeycomb with a 3-arm primitive unit cell (something like the figure attached; the figure is only representative and not drawn to scale). The...

07 August 2024 1,937 1 View

Why might the impedance values for DI water and 0.1X PBS buffer solution exhibit a decreasing and increasing trend, respectively over time (HP 4194A)?

Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...

05 August 2024 3,783 2 View

What do you consider to be the most relevant elements of EEG for studying cognitive biases?

I've seen articles that primarily focus on alpha and beta activity in the frontal regions, but these studies often compare healthy subjects with those having various pathologies. I haven't seen a...

31 July 2024 7,259 1 View

How to calculate conductivity using Electrochemical Impedance Spectroscopy's Nyquist plot?

Hello everyone, I am new to this characterization but watching videos on youtube I have already plotted a Nyquist plot (Z' and -Z'') and already fitted models on my material using Zsim. But now I...

29 July 2024 1,376 0 View

Why semicircle of nyquist plot is not complete?

While I am doing HER, I noticed that nyquist plots of Electrochemical Impedance Spectroscopy (EIS) is not complete. Will it affect for the Linear Sweep Voltametry (LSV) data? However, I can found...

26 July 2024 7,542 4 View

Is it possible to do transient simulation in HFSS in presence of magnetic biasing?

I have designed magnetic material with different biasing conditions in HFSS. Now I want to give an RF AC signal and do a transient simulation in HFSS. Is it possible to do in HFSS? Please help me...

24 July 2024 9,319 5 View

What binder would be the best choice to modify glassy carbon electrode with a 2D Material like Graphene or MXene?

I am trying to drop cast 2D Materials on Glassy Carbon Electrode for Cyclic voltametry and EIS purpose. What would be best binders to use?

23 July 2024 5,776 2 View

Can anybody provide me the Matlab code to plot the attached picture (Time-Frequency Domain), please?

Time-Frequency Domain

19 July 2024 8,031 2 View

How do you decide an optimal AC amplitude for non-faradaic electrochemical impedance spectroscopy?

I work with planar interdigitated electrodes (IDEs). The finger width and the spacing between the fingers are 5 micron. The surface of the IDEs is coated by a non-conductive polymer layer...

16 July 2024 5,031 1 View

Why is EIS important even if the cell is only run under DC conditions?

If impedance is an AC phenomenon, or if AC causes certain cell phenomena to become prominent at certain frequencies, why do we care about them? Under working conditions the cell will be...

14 July 2024 6,321 1 View