Hello. I'm almost done and I hope this is the last obstacle. After correcting errors, I will make the network much smaller and have it analyzed. I want a heat transfer between the pad contacting the disc and the 2nd pad. But I get the following errors. I searched a bit but could not find a clear solution. Thank you in advance for your answers ...
errors :
1: Integration and section point output variables will not be output for deformable elements that are declared as rigid using the *rigid body option
2: There is zero HEAT FLUX everywhere in the model based on the default criterion. please check the value of the average HEAT FLUX during the current iteration to verify that the HEAT FLUX is small enough to be treated as zero. if not, please use the solution controls to reset the criterion for zero HEAT FLUX.
3: No heat flow will occur between the slave and master pair (assembly_s_surf-17, assembly_m_surf-17). Heat generated at the interface will not flow into either surface. '' Connection between 2 pads ''
- Badges
- Science topic
- Similar topics
- Biological Science
- Bioecology
- Systems Ecology
- Landscape Ecology
- Connectivity