How can I measure MMP-1 protein activity or protein level from liver tissue?

Instead of checking only the mRNA level, I want to check the active protein level of MMP-1 in Liver tissue from mice. How can I do that?

03 March 2021 1,763 2 View

Binary Logistic Generalized Linear Mixed model in SPSS. Is it doable?

I want to analyses the proportion of swimming sperm of three species of fish in two salinities. To analyse the proportion of swimming sperm in a Generalized Linear Model, I would use a Binary...

03 March 2021 2,297 3 View

Looking for Materials with high thermal expansion coefficient and high temperature resistance?

03 March 2021 8,272 1 View

Guidelines for survey (question type) analysis?

Hi. Please tell me what guidelines should i need to follow for questionaries' type research work in India. It is not hospital based work, we are conduction basic institutional based qualitative...

03 March 2021 2,037 3 View

What are the values needed for gabor filter's parameter for cifar10 data?

Hi, I implemented a code to gabor filter cifar10 data but the images after being filtered and stacked are not clear like the original images. I think the problem is in the way I am using the...

03 March 2021 6,317 1 View

Can we block unwanted images during the x-ray prediction?

i am try to classify the x-ray images. During classification , can i block unwanted images (except x-ray image).

03 March 2021 7,100 1 View

No title

03 March 2021 5,360 2 View

What techniques can I use to determine the miscibility of polymer blends?

The term miscibility refers to the single-phase state in thermodynamics. I do not mean the compatibility of different components. To determine the miscibility I know several techniques such as...

03 March 2021 4,107 4 View

Sample dilution for quantitative analysis using ELISA?

If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis

02 March 2021 7,670 3 View

The procedure compute?

02 March 2021 5,204 3 View

What do I do with DLS peaks that are from the buffer?

I'm looking at the aggregation of my protein sample using DLS. Unfortunately, my buffer (20mM HEPES) also results in a set of peaks. These are at approximately 1 and 1000 d.nm. The lowest peak...

01 March 2021 9,015 2 View

What low-cut filter (high Pass frequency) to be used for response spectrum (Tripartite plots) ?

What low-cut filter (high Pass frequency) to be used for the response spectrum (Tripartite plots)? I am currently working on differentiating between hard/soft site responses in Indo-Gangetic...

21 February 2021 9,273 2 View

Can an airplane stay up in the the air without moving forward just like helicopter ?

How the lift and weight cancel each other perfectly for a helicopter to stay it motionless? Because its propeller do generate huge amount of lift due to air pressure plus a blend of air stream...

09 February 2021 3,990 14 View

FLIM Signal to noise ratio of a time series - can I use dark frames to measure noise?

I am doing an analysis on some FLIM data in the form of time series image stacks. I need their signal-to-noise ratio. Recording starts several picoseconds before the excitation pulse, so no sample...

08 February 2021 7,169 3 View

How to eliminate noise when using a sensor with instrumentation amplifier and giving it's output to Arduino?

When I am trying to implement a pressure sensor through instrumentation amplifier and then giving it's output to Arduino, I am getting garbage value due to noise, so how to eliminate it.

05 February 2021 8,598 11 View

How can I quantify background noise in a bioacoustic file?

I am using Audacity to analyse the presence of birds and frogs recorded with a SM4 recorder (Wildlife Acoustic). Background noise (rainfall, wind) is an important variable to consider that can...

28 January 2021 2,989 3 View

ASTM or ISO standard test for duplex coatings?

Dear all, I would like to conduct scratch and linear reciprocating tribo-test on my magensium alloy, which has a plasma electrolytic oxide (PEO) layer of about 20 um and 10 - 20 um of Parylene...

25 January 2021 9,709 2 View

Why doesn't semen analysis usually use darkfield microscopy?

From examples I've seen online, brightfield has too-low contrast and phase contrast has large (diffraction?) halos that can look like noise.

15 January 2021 3,155 1 View

What is the formula used for the calculation of L10?

Is there any formula, which can be used for the calculation of L10 i.e, peak noise level? Please give your opinion?

14 January 2021 8,408 3 View

Does Lucifer Yellow interfere with miniEPSC/IPSC recordings?

I want to mark the neurons I am recording from during whole cell Patch clamp. I am thinking of using Lucifer Yellow. Does it increase noise during recording? What are the better alternatives to...

04 January 2021 7,791 3 View