Species accumulation and Rarefaction curves?

07 July 2018 0 3K Report

Hi again, how do I plot Species accumulation and Rarefaction curves based on the Chao1 and Chao2 results I obtained for my data? Can I do the typical line graph on Microsoft Excel?

Badges
Science topic

Similar topics
Mathematical Sciences
Graphs

More Tebogo Khoza's questions See All

How do I plot rarefaction curves using Chao1 and Chao2 values?

Hi all. I have used EstimateS to calculate Chao values for Insects found in 3 sites. I now need to plot Chao means and errors to compare the sites. Can I simply plot on Excel?

06 July 2018 1,139 0 View

How to interpret Chao1 and Chao2 values?

Hi all, I am a student and my statistics knowledge is minimal. I have three data sets for three sites. I sampled insects over 12 months. The sample sizes are not the same (12 for two sites and 24...

05 June 2018 9,280 9 View

How to convert a privately loaded document into a public document?

I attempted to make a privately uploaded text public but a window appeared that said an error occurred. There was no explanation provided as to why there was an error or what might be done to...

05 August 2024 8,025 7 View

What is meant by baseline of FTIR data?

I got comment on my FTIR data figure from a reviewer. The reviewer said "FTIR data in Figure should be repeated. there is no bassline." I made Y off set comparison graph of FTIR on OriginLab. Can...

03 August 2024 6,070 3 View

Is the mentioned CV graph a valid one as this graph have only one peak prominent (reduction)?

I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...

31 July 2024 9,697 0 View

Entropy measure and QSPR modeling in Graph Theor. How to construct the table for lengthy equation?

The entropy measured of molecular graphs plays a crucial rule. The network structures in some cases are very lengthy calculations to handle. Some author avoid to construct table where as most...

30 July 2024 3,126 0 View

Hi there, someone has the SeinFit software for windows because I cannot download it?

DOS version.

29 July 2024 6,064 1 View

There is possible way to calculate experimental DOS from the UPS spectrum of the material. How to calculate the DOS from UPS?

Here, I have attached the UPS graph. I'm trying to calculate the DOS/DOVS from the UPS.

29 July 2024 4,971 1 View

I need a reliable source or an example supported by excel sheet to understand Fuzzy Vikor?

27 July 2024 5,916 1 View

Critique Calculaltion in Topological Indices and QSPR Modeling?

The first step is to analyze a 2D molecular graph and implement partitioning techniques to calculate the topological indices. Secondly impose statically tools to generate QSPR model, may or may...

24 July 2024 9,644 1 View

How to do calculation of Louvain methods calculation for excel sheet and and is there any software available?

The Louvain method – named after the University of Louvain where Blondel et al. developed the algorithm – finds communities by optimizing modularity locally for every node’s neighborhood, then...

23 July 2024 6,659 0 View

Abaqus cylinder buckling riks analysis?

hi, I am doing a risk analysis of a cylindrical fuselage with windows. I have applied contact interactions between the different parts, and I have applied a unit value load to a reference point,...

20 July 2024 647 2 View