I want to simulate pedestrian walking in a beam in Matlab or Python in order that I can couple with fem so I can get the dynamic response under these loads.
Someone can me get some ideas how can I do that?.
Thanks a lot,
Best regards,
Nati
Look at this doc it may be helpful for your topic. Good luck.
Dear Researchers I am trying to write a code in Python to extract accelerations, displacements and stresses after a dynamic analysis using Abaqus. However, I am facing some problems such as I...
03 April 2018 415 4 View
07 August 2016 5,612 1 View
07 August 2016 9,860 2 View
Dear all I am new in Abaqus, I want to do a modal analysis in order to obtain the local modal parameters in a point of the model (mass, stiffness) associated to a mode. But, I cant obtain that...
06 July 2016 155 3 View
Hi! How can I put a Concentrated sinusoidal load (pt=700*sin(2*pi*fl*t)) in abaqus? Many thanks
02 March 2016 959 4 View
Hi, I am trying to construct a multi-layer fibril structure from a single layer in PyMol by translating the layer along the fibril axis. For now, I am able to use the Translate command in PyMol...
02 March 2021 4,569 4 View
I want to do a parameter study of a aixsymmetric cylinder in Abaqus. I want to create several jobs where I get the stresses for 3 different points in my model. These points are defined. I wrote a...
01 March 2021 10,078 1 View
I am working on roof joint and trying to simulate the behaviour in Abaqus. I am successful in running the model but the final graph does not follow the experimental curve in the negative direction...
01 March 2021 6,661 3 View
Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...
01 March 2021 2,327 1 View
Which is suitable for use with Python? MySQL or SQL Server? What is your suggestion?
01 March 2021 3,422 3 View
The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...
28 February 2021 6,560 14 View
Please, if Gaussian Parameter optimization is possible in this code structure
28 February 2021 278 3 View
I have input and output data set for "ANFIS modeling in MATLAB", and I am getting some negative predicted values of output in testing. However, the predicted values of output in training are...
28 February 2021 3,459 3 View
I wanted to add an extra parameter to the existing Johnson cook equation in the ABAQUS simulation. How to add those extra parameters. Ref: A modified Johnson-Cook material model with strain...
28 February 2021 4,841 3 View
I am working on modeling and simulation of biomecanical material behaviour, I have succeded on simulating skin using anisotropic hyperelastic material, on APDL and in our lab's finite element...
28 February 2021 552 3 View