Hi all;
I want to ask three questions; the first question is: is the serial communication between PC and F28377s requires RS 232 cable or not. The second question: i want to communicate serially between PC and f28377s, what are the blocks and their libraries used in the target side and host side. The host PC side contains sine wave generator which is required to be sent to f28377s for processing and then returned back to PC. The target side contains gain which is required to be burnt on F28377s. Briefly i want to send sine wave from MATLAB simulink to F38377s to be gained and then returned back to PC to be read in scope in matlab. The third question is: the boot switches in f28377s which are located on its board, what are their functions in this application.
