07 May 2017 3 5K Report

Some one explain, Bio fouling occurred in seawater reverse osmosis and how to control? why its happening specially below configuration of pre treatment.

Seawater+ DAF + Ultra filtration 

More Kannan Muthali's questions See All
Do we have any empirical model to model the combined effect of carbonation and chloride attack in concrete concerning climate change?

Do we have any empirical model to model the combined effect of carbonation and chloride attack in concrete concerning time-dependent temperature, relative humidity and concentration of carbon dioxide?

08 February 2021 4,277 1 View

Does AMBER or CHARMM force field parameters have coarsed grained side chain parameters?

I need to coarse grain the side chain with a single atom. However, what force field parameters do I have to use. Does AMBER or CHARMM have any parameters and partial charges for coarse-grained...

31 January 2021 7,091 3 View

Where can I read the force field parameters of amino acids and protein ?

I am a beginner in the field of molecular dynamics and biochemistry. I need the parameters such as van der Waal radii, partial charge of each amino acid. How do I read directly the parameters from...

20 January 2021 3,541 3 View

Can anyone clarify what is the difference between 'R' software statistics and SPSS Statistics?

I recently learned few things about 'R' programming language. It is open source / free platform in many aspects. R helps to descriptive statistics, inferential statistics, multivariate...

17 January 2021 1,089 20 View

Does anyone know what is the minimum variables required for standard deviation? and why large datasets is considered as reliable data?

For Descriptive statistics, we usually find out mean, median and mode as well as standard errors and standard deviation. Almost in research articles, I can see mean with standard deviation only....

10 January 2021 4,913 3 View

For mineral / compound characterization studies like FTIR, SEM, XRD, how many replicates should be taken for data analysis?

If we do some spectroscopy technique for only one sample, is it enough for data analysis or we have to do multiple samples from each treatment for getting authenticate results to publish in...

09 January 2021 5,896 2 View

What is the reference for the partial charges values for peptides shown in avagadro?

I built short peptides in Avagadro, using Build--->insert--->peptide. After constructing the short peptides of 4 amino acids(tetrapeptide). Under the drop-down, View--->Atomic...

27 December 2020 778 3 View

How to compute the Backward kinematics ?

I have been reading this paper. https://cnx.org/resources/9c9fe5128dfef772b498990a94c49df16c4f09ee/transformation_derivations.pdf Here, they have computed for forwarding kinematics to compute...

18 October 2020 8,208 3 View

How to plot the following XYZ coordinate file?

I am trying to plot the following points in VMD. It is plotting as points. However, It is not connecting the points from A to B to C to D to E to F to H by a line. How do I do it? If not in VMD,...

15 September 2020 4,282 3 View

What is the difference between TURN, COIL and BRIDGE in Protein structure?

I have been reading the following (open access) journal, In this paper, they have collected data samples from the loop region and categorically classified into TURN, COIL and BRIDGE, 3-10 helix...

10 September 2020 4,033 4 View

Similar questions and discussions
How to separate water from glycerol solvent in a solvent recovery vacuum distillation column?

I am currently doing my third year design project. I have been assigned to design a glycerol recovery column in vinyl acetate monomer production. The process unit before the recovery column is an...

01 March 2021 9,525 4 View

What is the state of the drug inside solid lipid nanoparticles (SLNs)?

I am a little confuse with the mechanism of solid lipid nanoparticles (SLNs). The main point of encapsulating drugs into SLNs is because some drugs have low solubility in water. Therefore, SLNs...

01 March 2021 3,703 3 View

Why is the sum of the elements in a row in a Q matrix equal to zero?

When explaining substitution models, the substitutions are expressed as Q matrix. Why is the sum of the elements in a row zero?

28 February 2021 3,864 3 View

Are protein samples in SDS compatible with ELISA?

I have used an AllPrep DNA/RNA/Protein Mini Kit QIAGEN kit to extract RNA and protein from my samples. At the end of the protein purification, I resuspend my protein in 5% SDS. Will these samples...

28 February 2021 7,370 3 View

Does different dilution factors affect negatively on NH3 reading ?

I have a sample of treated water sample & asked to obtain ammonia conc. in sample using a machine with 5-25 ppm detection range. However, upon testing with different dilution factors, all...

27 February 2021 8,483 3 View

LEDs on Vis Light photo degradation of MB water sol via N doped TiO2 in a mini flume?

Good day to all, I have no experience with light emitting diodes. I am building a glass mini flume to demonstrate the photo degradation of Methylene Blue in water running over self cleaning...

26 February 2021 4,026 5 View

How to replicate the well conditions of a crystal hit with 20%(w/v) isopropanol?

I had a crystal hit in a well with 0.1M HEPEs pH 7.5, 10%(w/v) PEG 4000, and 20%(w/v) isopropanol. Why is isopropanol in w/v here if it's just solvent? How do I recreate this well condition?

25 February 2021 9,761 1 View

How to increase solubility of Poly acrylic acid in Dioxane solvent?

I am working with Polyacrylic acid (100.000Da) and instead of water, I need to use another solvent (dioxane) to dissolve PAA. However, because of the high molecular weight, it's quite hard to...

25 February 2021 2,225 5 View

To date, according to health authorities, 30% of the population's diseases are initiated by drinking water pollution. Do you know this problem?

The main studies are as follows: * regular and timely receipt of information about the state of the environment using automated systems (stationary and mobile); * operational analysis of the...

23 February 2021 912 5 View

Is it possible to define biogas as a fuel in the reformer process(scwg) in Homer software?

Hi every one Is it possible to define biogas as a fuel in the reformer process(scwg) in Homer software? Biogas fuel is not available in the options thanks

23 February 2021 6,518 3 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close