Reynolds stress modelling (LRR, SSG) for multiphase flow using interFoam solver in OpenFOAM?

04 March 2021 1 5K Report

Has anyone tried modelling multiphase flow (interFoam solver) using LRR or SSG turbulence closure in OpenFOAM? I want to discuss about it.

Subhojit

Masoumeh Hashempour

Yes, and it does not show good precision.

Badges
Science topic

Similar topics
Mathematics

More Subhojit Kadia's questions See All

Possible reasons for shifting of whole rock at one end of isochron in Sm-Nd dating?

Usually whole rock plots in between the minerals in isochrom.. Is there any published literature where it was shown that the whole rock is plotting at the lower end of isochron.. Just need some...

08 August 2016 360 7 View

Is it possible to estimate the age of volcanics from a volcano-sedimentary successions by U-Pb zircon analysis?

As there are both, inherited detrital as well as insitu crystallised zircons in the volcano-sedimentary succession....So when there is no such big differences in the ages from the sediments and...

30 July 2015 2,718 10 View

Why did evolution favor ATP and not GTP, TTP or CTP?

Why did evolution favor ATP and not GTP, TTP or CTP as the powerhouse of the cell for many reactions? I know GTP is used in some cases - but only few. TTP and CTP even more rarely. What gave ATP...

02 November 2014 4,398 28 View

What are the possibilities of eradicating cervical cancer in the next two decades if we can plan on implementing HPV vaccination at a larger scale?

Human Papilloma Virus (HPV) is the main cause of cervical cancer. In addition, HPV is also responsible for many other cancers including vulval, vaginal, anal, penile and oropharyngeal cancers....

30 March 2014 8,855 17 View

What are the options for early detection and/or screening for breast cancer in low- and middle-income countries (LMICs)?

70% or more of women in LMICs present with late stage breast cancer (BC). Most of those are ER-BC which occurs at a younger age and therefore in more dense breasts. Due to dense breasts, and of...

05 December 2013 3,459 29 View

How to determine positive-stained cells in FACS? Use isotype or unstained control?

To compare positive and negative cell populations in flow cytometry, should I compare unstained cells with antibody stained cells? Or with the isotype control? Most papers show comparison with...

06 August 2024 6,728 6 View

Why do we equate male and female arousal?

Women, on the other hand, can become physically aroused (increased blood flow in the reproductive organs) without becoming psychologically aroused even in the slightest. (Robert Weiss)

05 August 2024 9,537 2 View

How to make a Lateral flow control line more uniform?

We have a lateral flow test on Sartorius 140 NC. The conjugate is gold-monoclonal antibody. Using different control lines (GAM, protein A, protein G) we get a very strong leading edge with reduced...

31 July 2024 4,510 3 View

Suggestions for the Annexin V Positive Control ?

Hello everyone, I am currently using washed human platelets to stain Annexin V as a procoagulant marker. Additionally, I am staining with PerCP-CD61 to identify platelet cells. So far, I have...

29 July 2024 8,624 1 View

Why cannot i find my protein on cell surface after antibiotic selection of expressing plasmid?

I cannot confirm cell surface protein expression by flow cytometry even after transfection and antibiotic selection of cells. Does it take long for proteins to express on the cell surface? the...

28 July 2024 3,178 3 View

Problem with Two-phase simulation?

Hello; I am conducting a CFD study on two-phase flow in a separator, utilizing refrigerant as the working fluid. For this study, I have implemented pressure inlet and pressure outlet boundary...

25 July 2024 2,309 5 View

Flow through curved domains?

Hi everyone, I am working on a curved domain in which a ship is situated in the middle (geometry is given below). In my understanding the general fluid flow is parallel to the x axis from inlet to...

25 July 2024 9,058 4 View

BD Cell Viability Kit - TO evaporation?

Hello, I'm conducting flow cytometry experiments using the BD Cell Viability Kit and I've noticed that the TO solution ends much faster than the PI solution. I store the solutions according to...

22 July 2024 2,257 0 View

Can I use CCCP instead of H₂O₂ as a positive control for ROS measurement through flow cytometry?

I am giving starvation stress to the soil amoeba (Dictyostelium discoideum) cells in my study groups and using NAC as a negative control. I am using DHE for ROS measurement.

20 July 2024 6,354 0 View

I came across oscillations in a pressure profile for a pipeline flow along the axis of a cylinder, how do I prove that these are not numerical err?

In terms of CFD, we often analyze the stability of the error using Von-Neumann analysis, especially for FDM based problems. Should we follow the same approach for a compressible fluid flow using FVM ?

13 July 2024 6,296 5 View