Dear All, I am facing a serious problem. The output (red highlight) bottom is not arising in some of my CFA in AMOS. In some cases, it is arising, but in some cases, it is not arising. I have seen all most all possibilities , but not arising. Sincere request to solve this issue.
I recommend Byrne's (2013) book of structural equations in AMOS
Yes, I have gone through the relevant portion of the said book. But could not find any way-out.
Hello Saroj,
You are unable to get the AMOS program to generate output for your model, and you are using the visual interface (and not the visual basic syntax for input), is that correct?
Have you: (a) defined all of the manifest (observed) and latent variables of the model; (b) identified all appropriate error terms; (c) set paths that make sense for the model to be analyzed; (d) avoided duplicate names; (e) specified constraints; (f) linked to a valid data set; and (g) saved the model?
If none of these is at issue, perhaps you could furnish an example. That might help someone be able to give more specific advice.
Good luck with your work.
Dear Sir, yes, all your suggestions are taken care of. Still the red highlighted out put is not being activated. Where as another CFA of the same research is successfully showing. Please see the attached file, where I am failure. And please see another CFA of the same research work, where that red botton is activated. The CFA, where I am unsuccessful is related to consumer attitude. The CFA, where I am successful is related to consumer learning of the same research work. Of course variables for both CFA are different set. Sincere request to help me
Please see that whether the error term is added to all indicators; and please see that constraint (1) is assigned to the arrow, which is leading to a latent variable or construct. Later-on I had taken care of all these things and I got success.
- Badges
- Science topic
- Similar topics
- Physical Sciences
- Materials Science
- Materials
- Inorganic Materials
- Ceramics