Plasma vs. Formaldehyd?

Rainer Herden @Rainer-Herden

18 August 2022 0 9K Report

Question for the round:

Can atmospheric cold plasma be used to split or remove formaldehyde? Both in the air and on surfaces.

Thanks and greetings

Badges
Science topic

Similar topics
Mathematics
Algebra
Matrix

More Rainer Herden's questions See All

Can you provide occurrence data for the rock partridge (Alectoris graeca) in Switzerland?

I am looking for additional data as the amount of occurrence data on gbif is very limited. In particular I look for data with little spatial uncertainty, i.e. with coordinates fixed by GPS or in...

30 June 2019 6,224 5 View

Why does Geneious couldn't fit my custom ladder?

I use a Geneious Trial Version 11.0.4 to look at my microsatellite data. As my samples run with a custom ladder I altered the ladders.txt. However, Geneious could not fit the ladder. On the...

08 January 2018 9,041 2 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

Sample dilution for quantitative analysis using ELISA?

If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis

02 March 2021 7,670 3 View

Where can I find atmospheric measurement profiles (temperature, density, etc.) between 300-800 km altitude?

I am investigating thermospheric mass density profiles between 300-800 km altitude. I would like to compare the variability with other parameters, including temperature, electron content,...

01 March 2021 5,902 3 View

Does anyone know of a predictable relationship beween surface gravity and atmospheric composition?

The attached file demonstrates that there is a predictable relationship between the structural density of a terrestrial body and its none-rotating surface gravity. Using Newton's gravity law of...

26 February 2021 2,317 3 View

Why do the air flow results vary totally when adding scalar in CFD ?

Dear All, We are using Autodesk cfd to calculate the air flow in a single sided naturally ventilated room, where air flow depends only on buoyancy due to temperature difference between inside and...

25 February 2021 9,602 4 View

Modeling viscosity using model of Chung?

Hello, As part of simulation of gases mixture and water, I need to calculate viscosity of the fluid components and I am using relationships proposed by Chung et al. (1988). The irony is while I...

25 February 2021 8,053 5 View

IF troubleshooting: looking at an intracellular protein that localizes to the cell's and how to reduce increase in signal due to cell ruffles?

I am currently trying to stain for PI3KBeta in MDA-MB-231 cells. My current issue is that 1) beta stains all over the cell and 2) there is an increase in signal at the edge of the cell and this...

24 February 2021 8,582 1 View

Is is possible to pole with corona poling pellets of the sample material instead of thin films?

As it is highly probable that pellets will have a higher degree of air gaps and voids than thin films, is it possible to pole the samples with corona poling nevertheless? Or is there the...

24 February 2021 1,349 1 View

Is it efficient to do liquid biopsy to investigate the gene expressions of the tumor?

To do liquid biopsy and look for specific gene expressions there are so many published papers. Thera are different protocols and procedures used to isolate circulating cell free RNA or mRNA from...

23 February 2021 7,326 5 View

Have you ever experiencing air vent trouble in fermentation process?

Dear all, My research group is currently working with a 12-litre fermenter. Somehow, if we do the fermentation for more than 20 hours, the process will be more prone to contamination. Our current...

23 February 2021 1,908 2 View