How to remove the residual PDMS on the silicon mold?

Incompletely cross-linked pdms are difficult to remove.

01 March 2021 798 3 View

VIF very high, but correlation is low and coefficient is significant. Which one whould I choose?

Hello. I have a question whether if my coefficients (statistically significant) would be valid when VIFs are really high. In my model, there are independent variables(IV), moderating variables...

26 February 2021 956 13 View

How to clean up TEM grid with plasma cleaner?

I need to clean the hydrocarbon contamination on the carbon substrate of TEM grid. However, I heard that substrate could be broken by the powerful plasma. My substrate is pure carbon, with ~3nm,...

23 February 2021 3,262 5 View

How to remove the species data from rda data frame in R (only remain the sites/samples point)?

Dear everyone, When I using the rda function in r, I met this question. As you can see in the figure, there are a lot of deep blue points which refers to the species. But I would like remain...

15 February 2021 8,982 2 View

How to simulate enzymatic hydrolyis of sucrose in a CSTR coupled with ultrafiltration membrane with comsol?

Dear all, I am trying to simulate the enzymatic hydrolysis of sucrose with invertase in CSTR in Comsol. The reaction pathway is such that Sucrose + Water -> Fructose + Glucose. It is desired...

27 January 2021 2,525 4 View

How to design an Ultrafiltration membrane for a CSTR?

Dear all, I am designing an Ultrafiltration (UF) membrane coupled with a CSTR. It is desired to utilized a dead end stirred reactor. The main purpose is to separate the enzyme used from the final...

27 January 2021 7,924 1 View

Sb2Te3 thin film annealing and damage(break)?

21 January 2021 9,642 2 View

Is it possible to publish a paper contradicting Einstein's special relativity in any Journal?

I just developed a new theory on electromagnetic and plan to publish in a Journal. The findings are purely through strict mathematical derivation without any disputable assumptions and also...

13 January 2021 1,558 5 View

What is the significance of Per-Patient and Per-Tooth analysis in epidemiology?

Research in prevalence usually provide results in per-tooth/object level and per-patient level. What is the significance of these two values and which is actually more important/accurate? What are...

10 December 2020 4,248 4 View

For SIADH, does it cause edema and Hypertension?

I have found two teachings from different sources. One they said about blood volume increase and therefore the patient has oedema and hypertension. But, another source says when there is high...

08 December 2020 1,278 3 View

What are anisotropic electrical and optical properties of a semiconductor due to?

In some materials, properties such as band gap, thermal conductivity differ along different crystallographic axes. What are the basics?

01 March 2021 1,923 3 View

How the Ground Plane implantation is performed without damaging (and w/o varying the undoped nature) the top Si (8-10 nm) in FDSOI technology ?

It is a general practice to introduce Ground Plane in FDSOI devices under the BoX. The Ground Planes are introduced by Ion Implantation through Top Si layer and Buried Oxide. I wanted to know that...

24 February 2021 5,974 4 View

Can a semi-conductor material have different absorption coefficient?

Does the absorption coefficient of the semiconductor changes with the change in the structure of the semiconductor? If you have a thin film and nanowire of the same semiconductor, will the...

23 February 2021 9,799 4 View

How can we determine the band gap of a composite material that is made up of a composition of direct and indirect band gap semiconductor materials?

I have a direct band gap material and an indirect band gap material. If I made a composite of both through physical mixing. Then how can I determine the band gap of such a material as the Tauc...

17 February 2021 8,104 4 View

Is it possible to find the radiative/nonradiative lifetime without steady-state conditions?

I have a set of time-resolved PL measurements, to which I applied an exponential fit to extract the effective decay time. I now want to determine the radiative and nonradiative rates involved in...

03 February 2021 7,674 1 View

Any resist stripper which can remove thick metal based polymer residue and which is compatible with doped silicon ?

I am looking some resist strippers which can easily remove metal based polymer residue after post dry etch process. I have some candidates below but not sure if they are compatible with doped...

21 January 2021 3,008 3 View

What is the average lifetime of ODLAB acid inert heating plates?

Dear Colleagues, common hotplates have a short lifetime when used for acid digestion of rock/mineral samples. PTFE/graphite coated hotplates are much more expensive and should live much more than...

21 January 2021 1,208 3 View

What is the best way to calculate electrical conductivity of semiconductors and the same system with a layer of oxide using Quantum Espresso?

I have tried BoltzTrap, and EPW but I'm not sure whether Boltzmann Transport Equation is a right approach for a complex system (semi cond. + an Oxide layer or even the semiconductor itself). Also...

11 January 2021 4,597 4 View

How to calculate the band potential of a semiconductor material using energy band gap?

I am looking for methods to calculate the band potential of ZnFe2O4 and Fe2O3.

05 January 2021 6,416 2 View

Application for Ph.D. in Inorganic Chemistry?

I hope to have the opportunity to continue toI hope to have the opportunity to continue to do more in-depth research, do more in-depth research. My main field is to use semiconductor metal oxides...

04 January 2021 1,148 2 View