Firstly, the PVDF-based film is about 25 μm, and effectively poled.
Secondly, the structrue of the sensor is PET/ITO/PDMS/PVDF film/PDMS /ITO/PET.
You provide the schmatic diagram of your sensor. How it is connected in the circuit with component values.
@ Shiraz Sohail
Thank you.
The schematic diagram is shown like this.
When C connects A, D connects B, then I get output signal from oscilloscope by pressing the device.
However, when C connects B, D connects A, there is no signal.
Incompletely cross-linked pdms are difficult to remove.
01 March 2021 798 3 View
Hello, I have simulated a single battery cell using Thevenin equivalent circuit. For a battery pack, I have a large number of cells connected in series and parallel connections. Is there any way...
28 February 2021 2,116 1 View
I am familiar with finite element simulations and numerical schemes like the Gauss Legendre quadrature. I also know that the Gauss integration yields exact values for polynomials up to degree 2n-1...
27 February 2021 6,818 3 View
I am interested in evaluating mesh optimization solvers that converge to high aspect ratio unstructured hexahedral grids. In other words, I am interested in a solver that optimizes warpage,...
26 February 2021 7,279 2 View
I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...
26 February 2021 1,511 3 View
I want to remove PDMS oligomers from the surface of nanolayers. I have just read a very helpful paper about the compatibility of PDMS with different solvents( Solvent Compatibility of...
24 February 2021 7,845 5 View
I am trying to seek out some Transgenomic Wavemaker software (happy to purchase a computer too) to operate a fraction collector. The only way to connect to the fraction collector so far is to...
23 February 2021 9,181 1 View
I am working with several continous, environmental marine datasets at varying original spatial resolutions. My aim is to regrid each dataset to one common, high resolution grid. I am currently...
22 February 2021 2,290 2 View
Colleagues and I are about to begin a project investigating the role of town planners and local authorities in establishing the introduction of connected and autonomous vehicles (CAVs). What...
21 February 2021 2,247 3 View
Dear Research Gaters, Let me first add context to the question. I am looking to simulate the waste management system and resources of a city. The hardware devices I need to simulate include,...
21 February 2021 2,333 4 View