On partial thrust plot for a turbofan engine, shaft RPM and corrected RPM constant lines are plotted. Which one corresponds to fix throttle position?

09 September 2017 0 6K Report

Hi Everyone.

I am dealing with partial thrust and SFC curves (Husk plot) on which there are constant shaft RPM and corrected RPM lines shown. My query is that if i want to relate the throttle position with constant lines which one should correspond to a fix throttle position.A typical HUSK plot is attached for ref.

Regards

Badges
Science topic

Similar topics
Correction

More Farhat Asim's questions See All

How TSFC and thrust curves for an aero engine are obtained as function of height and mach number??

Hi everyone. I was wondering how the uninstalled thrust and TSFC with mach number and height variation is obtained experimentally. I have seen such curves are given by manufacturer. How do they...

08 September 2017 2,465 3 View

How TSFC curves with altitude,mach no and thrust are plotted

Hi everyone. I was wondering how TSFC curves are plotted. I mean by changing throttle we change the amount of fuel consumed and then thrust is obtained for a given mach no and height. Is this...

07 August 2017 6,736 0 View

How can we estimate the dynamic coefficients of aircraft ?

Hi everyone. I have to estimate the dynamic coefficients of aircraft such as Cmq, Calha_dot, Clr etc. I need to know the analytical as well as the experimental procedures in use. Please can...

06 July 2017 9,321 10 View

Waters 2707 HPLC autosampler problem?

I am using a 2707 waters HPLC device. When I try to inject a sample, it says missing plate or rack. I changed the needle and calibrated its position but I still get the same problem. I even get...

02 March 2021 1,408 1 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

Any research papers for extraction of nutrient deprivation on macroalgae? Analysed by HPLC-UV and GC/MS. Possibly from macroalgae genus Rhizoclonium?

I am doing my thesis on the nutrient deprivation on the macroalgae Rhizoclonium sp. I will be analysing the levels over a period of roughly 5 days by HPLC-UV and GC/MS. I will be using seawater as...

28 February 2021 6,477 1 View

Trouble with Charting with Google Earth Engine (Technical)?

Hello. I have a problem with the charting in google earth engine. I created an image collection by combining 5 image collections of five parameters and using ee.Join.inner ( ) and .apply ( )...

26 February 2021 7,084 2 View

No title

I am trying to find how to know the density needed for a pva electrospinning in a 0.6mm neddle, the electrospinning will be from top to bottom and the problem I really have is the solution because...

25 February 2021 2,615 3 View

Do you kow of any database containing data on retention time, log P and polarizability for a large number of molecules?

Hi, I am a chemistry undergraduate doing my dissertation project on HPLC. In my project, I need to predict the HPLC retention time of 20 aromatic molecules, the calibration set. To do this I will...

24 February 2021 2,602 1 View

How Can I clain a removal of a co-author?

I would like to make a correction in a co-author in your paper which is wrong. This name is also in other papers of Kenton Ko. Zey Ko is not a Co-author . The correct name is Zdenka...

24 February 2021 3,476 4 View

Is is possible to pole with corona poling pellets of the sample material instead of thin films?

As it is highly probable that pellets will have a higher degree of air gaps and voids than thin films, is it possible to pole the samples with corona poling nevertheless? Or is there the...

24 February 2021 1,349 1 View

Any easy method of analyzing vitamin D in foods by HPLC?

Looking for method of extracting and analyzing vitamin D in foods by HPLC

24 February 2021 7,524 7 View

How does the injection volume impact LLOQ and ULOQ in regression analysis (LC-MSMS)?

Hello, I have run into an issue that has sparkled a debate at work: is the LLOQ/ULOQ impacted by injection volume under the following circumstances: 1) Same dilution factor of all samples 2)...

23 February 2021 9,159 3 View