Hi everyone. I was wondering how TSFC curves are plotted. I mean by changing throttle we change the amount of fuel consumed and then thrust is obtained for a given mach no and height. Is this correct interpretation of these curves.
08 September 2017 6,287 0 View
Hi everyone. I was wondering how the uninstalled thrust and TSFC with mach number and height variation is obtained experimentally. I have seen such curves are given by manufacturer. How do they...
08 September 2017 2,465 3 View
Hi everyone. I have to estimate the dynamic coefficients of aircraft such as Cmq, Calha_dot, Clr etc. I need to know the analytical as well as the experimental procedures in use. Please can...
06 July 2017 9,321 10 View
I'm dealing with a mediation model and am using the PROCESS module in SPSS. Due to SPSS and PROCESS being limited in the imputation methods - being unable to handle multiple imputation - the other...
02 March 2021 4,362 1 View
Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !
02 March 2021 5,785 3 View
Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...
01 March 2021 2,327 1 View
I am investigating thermospheric mass density profiles between 300-800 km altitude. I would like to compare the variability with other parameters, including temperature, electron content,...
01 March 2021 5,902 3 View
I'm currently working on a piece which asks to conduct an ANOVA - looking at the effect of sporting group (2 levels), and exercise trials (two trials with six levels). I've computed this all...
27 February 2021 9,626 4 View
I am trying to find how to know the density needed for a pva electrospinning in a 0.6mm neddle, the electrospinning will be from top to bottom and the problem I really have is the solution because...
25 February 2021 2,615 3 View
I have obtained Partial Eta Squared Numbers through Two-Way Mixed Anova Analysis. My results for different constructs are: .105, .135, .038, .068, .061 respectively. I wanted to know, whether...
24 February 2021 7,122 1 View
I would like to make a correction in a co-author in your paper which is wrong. This name is also in other papers of Kenton Ko. Zey Ko is not a Co-author . The correct name is Zdenka...
24 February 2021 3,476 4 View
Hello, I have run into an issue that has sparkled a debate at work: is the LLOQ/ULOQ impacted by injection volume under the following circumstances: 1) Same dilution factor of all samples 2)...
23 February 2021 9,159 3 View
Hi every one Is it possible to define biogas as a fuel in the reformer process(scwg) in Homer software? Biogas fuel is not available in the options thanks
23 February 2021 6,518 3 View