nil
I am making polymer composite by solvent mixing method. When I am trying to add filler solution in polymer solution it quickly get solidified. How to make them then uinform? It doesn't give time...
03 March 2021 7,540 4 View
How would define the "good" and "poor" distribution of particles within the matrix. Is there a quantitative solution to assess the distribution of the particles, which then having denotation of...
28 February 2021 7,397 8 View
Is there any way to construct different initial filler shapes like triangle, square, rectangle, pillar, and tube in any simulation software.
20 February 2021 1,750 1 View
Hi all, I am currently working on some background calculations before I start a new project related to metal matrix particulate composites. I am trying to find a way to calculate the stress at...
19 February 2021 8,503 3 View
Dear all, I hope everyone is safe and healthy I do have a question please. Where can I find a drop-weight impact testing machine to test fiber reinforced polymer composite plates (CFRP and GFRP)...
17 February 2021 3,820 3 View
I want to cut epoxy filled nanocomposite for FE-SEM analysis. What is the best way to cut it without resulting in any cracks or change in position or alignment of the particle reinforcement ? Also...
28 January 2021 7,084 5 View
I have melt mixed to thermoplastic polymers. But I want to know the homogeneity of the composite. What are the methods to determine whether the composite is homogeneous or not? Please help.
20 January 2021 9,085 5 View
Hey, i basically want to simulate a tensile test to validate the damage model of my composite material. When using the instant stiffness reduction the results converge but are not sufficent....
12 January 2021 2,313 3 View
When a Carbon/PAEK material heated with an alternative current, I have seen a rapid/moderate/linear temperature drop after cutting the heat supply from the heat source. Even it continues for the...
11 January 2021 6,838 3 View
Does Epoxy clay nanocomposite sample require surface preparation. I am going for Gold sputtering to make the surface conductive. I guess there is no need to clean or polish the surface beneath the...
04 January 2021 1,943 8 View
