Any one working on nickle based alloys i need information
Retaining walls are relatively rigid walls
08 January 2024 2,487 1 View
Who is strategic leader? How to become leader? What are successful leaderships strategies? thank you for caring
23 September 2023 152 1 View
Why Quantitative research is better then qualitative research?
10 September 2023 2,289 4 View
I am working on Copper extraction by solvent extraction method, I have a question that after stripping process how I can analyze the organic for confirmation of copper available in organic.
25 August 2023 4,932 3 View
we are working on electrochemical reduction of CO2 in H-type reactor where i m getting Current density without supplying CO2, basically we get current density when reaction is occuring but in my...
23 August 2023 6,337 0 View
http://www.scfbio-iitd.res.in/dock/ActiveSite.jsp
30 July 2023 7,780 1 View
How I can calculate volume of Co2 when I use it in water by using gas flow meter? please guide me my WhatsApp number is +923322676617
04 May 2023 1,720 0 View
I am a Ph.D. scholar at BUCT and doing research on Li and Na Extraction by using Solvent extraction method, Is here any one who have expertise on this research area or doing research on this...
06 April 2023 345 0 View
How to extract capacitance of ferroelectric layer and Cmos as a function of gate voltage using Sentaurus software? How to extract surface potential of the NC FinFET device using Sentaurus TCAD...
17 March 2023 5,084 0 View
Heavy metals stress and their responses in plants through metabolomics approaches
10 March 2023 3,144 4 View
Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...
07 August 2024 9,563 0 View
How select composition for ods-high entropy alloys?
31 July 2024 2,795 1 View
Any suggestions with respect to etchant composition and holding time?
27 July 2024 6,925 2 View
The catalytic effect of retained austenite refers to the phenomenon wherein quenching steels with a small amount of retained austenite, when subjected to tempering at a specific temperature...
27 July 2024 8,508 0 View
I am working on powder metallurgy, and during the compaction process, the powder does not pelletize and remains in its powder form. To address this issue, I am considering using binders to improve...
13 July 2024 9,003 2 View
Waspaloy is considered the benchmark alloy. Due to the different gamma prime solvus temperatures, we couldn't adopt the same double aging treatment. Can anyone suggest how to select temperatures...
13 July 2024 2,417 1 View
In the expression for solid solution strengthening model that has been widely used in the literature use a linear form consisting of strength coefficient, and concentration of elements in wt.%....
11 July 2024 4,476 3 View
Using magnetron sputtering with an alloy target composed of A:B:C in a 2:1:1 ratio, the resulting thin film composition is A:B:C=1:1:1. How can you achieve a A:B:C=2:1:1 composition? What are some...
24 June 2024 1,605 0 View
Is there any suggestion on the explanation and reduction of stacking fault defects in high Al content InAlGaAs alloy lattice matched to InP?
24 June 2024 6,645 1 View
For the article, I need some references for the subject of checking the convergence of the temperature field parameter for the SPH part in Abacus, and I want to study this case with a few meshes...
13 June 2024 2,504 0 View
