If someone has any article oneffect of halloysite nanotubes on mucoadhesion then please share?
Oil phase is liquid paraffin.
05 June 2016 7,832 2 View
I have to make emulsion of cyclodextrin. Which chemical i must use as oily phase?
04 May 2016 8,707 4 View
Basically i want to know about solution of clay. Clay must make clear solution or milky solution is ok with its solvents in which i dissolve it?
04 May 2016 1,428 3 View
While i dry microbeads after formation, they stick with paper, filter paper or petri dish and lose its round shape. What i must do? any suggestion?
01 January 1970 2,162 6 View
I am preparing microspheres of PVA and Sodium alginate. But those are not hard. Those are appearing gel like. How to get hardened microspheres?
01 January 1970 9,654 6 View
Is it possible to prepare microspheres of two polymers, one is soluble in organic solvent and second is soluble in water.
01 January 1970 7,774 3 View
I am trying to make an SEM model in AMOS for my dissertation but having some trouble with getting a good fit. I am looking for relationships between self-efficacy reported on a Likert scale and...
26 February 2021 8,642 4 View
I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...
26 February 2021 8,183 3 View
Respected Professor's i hope you are doing well and happy. i need some information about carbon Nanotubes. before blending the CNT with the matrix the CNT has been introducing in some treatments....
24 February 2021 5,383 5 View
We have deposited silicon carbide on carbon substrate using one PVD technique. Due to amorphous behavior of SiC at low deposition temperature, we performed heat treatment of those films at...
22 February 2021 2,072 3 View
I am trying to calculate the rdf of water molecules present inside the Carbon nanotube. I tried to do the indexing first using gromacs tool gmx selection. But when it comes to calculating rdf, I...
17 February 2021 1,066 3 View
Possibily not an open access journal which does not add any publishing costs once being accepted. Thank you in advance
09 February 2021 717 6 View
I have attempted the formylation of the above mentioned compound using a very well reported protocol using secondary Butyl Lithium and TMEDA at - 78 degrees Celsius. I have done it quite a few...
08 February 2021 2,793 2 View
Which of the methods like water jet cutting, diamond cutting, laser cutting, etc. is more suitable to cut the carbon nanotubes reinforced epoxy composites into test sample to ensure the clean...
29 January 2021 1,354 5 View
The usual way of properly removing and collecting carbon nanotubes (CNT) is to sonicate the stainless steel plates coated with CNT under isopropyl alcohol (IPA) solution, remove the plates after...
28 January 2021 9,455 1 View
Dear researchers, I am planning on conducting a research on the relationship between Language learning strategies, by Oxford (1990) and self-efficacy. I have found Morgan-Jinks Student Efficacy...
22 January 2021 8,432 3 View