Methods of analyzing the competitive advantage of agricultural products?

More Afshin Yeganeh's questions See All

VDR gene in Echinococcus granulosus ?

In recent project we would like to evaluate the expression level of VDR gene in Echinococcus granulosus . For primer design we need that primer and the accession number of mRNA for this...

21 February 2021 8,673 1 View

How can extract RNA from plasma by trizol?

Hi Dear Colleagues, Could anyone explain an optimized protocol to extract total RNA from plasma samples? We would like to extract total RNA from plasma samples through Trizol, however, after the...

11 September 2020 7,456 3 View

SST data format for WRF?

Dear all, I intend to use SST data for my WRF runs, but data are in binary format and I need to convert them to GRIB2 format. I appreciate if somebody with same experience help me solve the...

19 January 2020 9,829 3 View

Can anyone help me understanding the marginal cost calculation in this article?

Hi Can anyone here help me understanding the marginal cost calculation in this article? Cost and effectiveness of emissions trading considering exch... what is the index in summation notation...

16 January 2020 6,063 3 View

Should the effective stresses be constant during the effective stress numerical analysis?

Assuming running the undrained effective stress analysis in FLAC3D via Config FLUID using the effective stiffness and strength parameters, are we expecting the constant effective stresses in the...

15 July 2019 6,096 3 View

How can one remove the water level from the FLAC3D simulation at some point?

Is it possible to deactivate the effect of water so that FLAC adds the amount of steady state PWP to the effective stresses in all zones such that all the stresses in the soil constitutive model...

31 May 2019 4,737 2 View

How are the horizontal stresses calculated in FLAC3D?

The very initial step of each project is setting up the in-situ stresses. Right after the said step as well as amidst the dynamic analysis, could you cast light on how FLAC internally does the...

27 May 2019 5,280 2 View

How to prevent limbphagia in spinal cord injured rats?

We observed lower-limbphagia from phalanx to knee in transection models of spinal cord injured rats. How can we manage and prevent it ?

05 May 2019 3,422 5 View

How to assign the appropriate values to the interface element properties in FLAC3D?

Hey There. I am seeking a batch of references whereby the cohesion, friction angle, and dilatancy of the interface element, e.g., between a concrete foundation and the soil mass, could be...

13 March 2019 1,149 2 View

Does anybody know any other visualization tool such as YellowBrick for Machine Learning visualization in Python?

I need a visualization tool similar to YellowBrick for the visualization of dataset and Machine Learning results in Python.

07 January 2019 2,503 2 View

Where to find data on trees in tropical agroforestry?

Hi, I'm looking for data (mainly related to management: growth rate, canopy size, soil and climate preferences, etc.) about tropical trees used in tropical agroforestry. Have you ever heard about...

28 February 2021 7,356 8 View

How we can measure Kemp % in wool without using of benzene?

Would you please let me to know about the methods for measurement of medullation and Kemp % on animal? My problem is that the wool sampling and sending to laboratory is not possible. So I would...

21 February 2021 7,260 4 View

Is the box plot of climatic indices better illustrate from daily data or annual data?

Hello, I hope you have a good time. I work on a research project about temperature indices. Due to the high number of indices, I only work on tables and maps on an annual time scale. In other...

19 February 2021 9,742 2 View

How to differentiate the economic productivity in agriculture and in manufacturing sector?

Most of the references I found were on the economic productivity in agriculture but very limited application in manufacturing sector. I would appreciate if anyone could share the references on...

15 February 2021 8,342 7 View

What is/are the best ML classifier(s) for Sentinel2 images?

Hi I am trying to segment a sentinel2 image. At this stage, I want to run a binary classifier that assigns each pixel to either farm or non-farm pixel. For this purpose, I have 4 10m bands...

15 February 2021 3,596 9 View

What effect size should i use for a meta-analysis when study data violate normality assumptions?

I'm looking for advice regarding what effect size to use for meta-analysis. Our question is whether the number of individuals in a group affects the per-capita productivity of that group. Does...

10 February 2021 5,510 8 View

Can I modify vermiculite or perlite by adding nutrients to control a certain situation?

I need to assimilate a determining condition for the plant. However, I need to ask you if it is possible to change the properties and concentration of plant nutrients in this material like perlite...

04 February 2021 8,616 11 View

Is there a statistical technique that can be used to model these changes?

Hi everyone I have a dependent categorical variable of three levels, corresponding to three sectors of activity in the agricultural field, A, B and C and within each of them there are...

30 January 2021 2,876 13 View

Helicoverpa armigera eggs are not hatching in lab condition, why?

Dear RG friends, I am providing a complete H. armigera diet for larvae and maintaining the eggs in the growth chamber as well as in-room conditions. But since three months, eggs laid from the...

21 January 2021 5,546 32 View

What are the merits and demerits of GAN and classical data augmentation in plant leaf disease detection and classification systems?

anyone suggest what are the merits and demerits of GAN and classical data augmentation in plant leaf disease detection and classification systems

21 January 2021 5,135 5 View

Tiri Gyang

Try to explore policy matrix analysis commonly called PAM

Sunday Brownson Akpan

Apart from the policy matrix, you can compare the product volume of sales, market competitiveness, profit/gross margin levels and even factor productivity.

Mamerto Reyes Hernández

If you can read Spanish, there is a document you can review:

Article Una nota sobre las ventajas comparativas y competitivas