Level 1 pre-post multilevel regression: Panel data or ANOVA approach?

Dear colleagues, I am currently teaching myself in multilevel analysis using educational data. I found few to zero literature on basic analysis methods. In my context we frequently use level-1...

17 February 2021 9,378 5 View

Reliable and Valid Instrument for Causes of Medical Errors?

Is there any questionnaire/survey that measures the causes of medical errors? Example: physician negligence vs. systemic issues. Looking for a reliable and validated instrument. Thank you!

15 February 2021 2,874 4 View

Should the AUC in a concentration-time graph of a subcutaneous implant be roughly the same for poeple?

I have 2 concentration time curves of a subcut drug implant. the first group has a peak around the 50 day mark where as the second group does not. Both groups received the same implant by the same...

10 February 2021 2,305 3 View

Software for flow cytometry-like gating of data sets?

I am currently trying to do image based cytometry from fluorescence microscopy images. From the images I extract data such as cell size and a number of fluorescence intensities. Is there any...

09 February 2021 6,278 1 View

Can A. thaliana splice algae genes?

24 January 2021 329 2 View

Does long term preservation (10years) of Collembola in 99% Ethanol affect recovery rate of extraction by flotation?

Hello! I am currently developing an automated counting approach using Fiji to count Collembola from pitfall trapped samples that have been stored in Ethanol (99%) since 2010. I use flotation (tap...

13 January 2021 659 2 View

Co-stain Lectin PNA FITC conjugate with an uncojugated primary antibody?

Hello, I am planning to stain retinal tissue sections for IHC and want to co-stain cones and rods. For this we plan on using a Lectin PNA From Arachis hypogaea (peanut), FITC Conjugate for cones...

12 January 2021 583 1 View

How to use Abaqus USDFLD subroutine to vary stiffness?

Hi I have a problem where I am trying to vary the stiffness spatially across a structured interface. The whole idea is to vary the stiffness vertically, with a bulk stiffness of 8GPa decreasing...

06 January 2021 262 3 View

I really need help with cov-2 pseudotyped lentivirus production. Support?

Hi, i'm desesperate. i'm trying to produce lentivirus usinf BEI resources kit NR-52948. 24 hours after transfection i detect a massive GFP expression in my 293T cells. After 72 hours i filtered...

30 December 2020 9,889 6 View

How can i estimate the total phenolic content from a plant extract?

Suggestions and recommendations are welcome. A protocol used and experience would also be helpful.

25 December 2020 9,807 4 View

Do we need to write protocol for a second study of a systematic review that has been registered and published?

I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...

03 March 2021 8,920 3 View

How to upload pdf of my articles published?

How to upload pdf of my articles published?

03 March 2021 2,183 3 View

Would adding books published in Lambert Publishers increase my RG impact?

There are some books published in LAP. Shall I add it to the RG?

02 March 2021 2,753 1 View

Is Journal of Agricultural Research a predator?

it is published by Juniper

28 February 2021 354 4 View

How can I publish a manuscript in free or low cost journal with good H-Index?

Dear all I am going to publish my manuscript which is from my thesis in a good H-Index journal but I found them very expensive(I don't have financial support) based on the exchange currency of my...

28 February 2021 7,800 6 View

Which software is better to write systematic review paper?

We have seen some authors use some software to write review paper. As obvious, the study of all published papers concerning our studying field is not possible and these software can help us to...

27 February 2021 6,296 1 View

Can I put a figure that was drawn by Bio-Render in publication paper?

I want to publish paper in journal but I have figures which have drawn with bio-renders, can I put them in the paper or which other software I can use to draw them?

27 February 2021 8,179 1 View

Can anyone please help me in processing SAR SLC data to generate interferogram using SNAP?

I have two scenes of the study area, one top and the other bottom. As per the tutorials and papers published, the step include coregistering the master sand slave images. However, when i try to...

24 February 2021 6,372 1 View

How do I change a preprint to published?

I want to know how to change the status of an article.

21 February 2021 1,536 2 View

How I can add publication with maiden name?

Good morning, can You please tell me how I can add an article that was published under my maiden name? When I try to add an article with this name, it appears information that I should be an...

21 February 2021 6,866 3 View