What are your tips to write the discussion section of your scientific work in an efficient way?

Writing the discussion section is always the scariest part of a paper or a thesis. I came up with some ideas to make it less difficult, but would like to hear other tips! Here are my two bits:...

04 November 2020 6,808 3 View

How can I determine the total antibodies in the serum of bovines with ELISA?

I want to determine if there is a difference in the amount of total antibodies in the serum of different bovines, I was thinking of doing it with Elisa sandwich. Has anyone tried it? What initial...

13 August 2020 2,412 4 View

What measures have your labs/ institutions put in place to mitigate the impact of COVID-19 on early career-researchers?

Early career-researchers are disproportionately affected by the COVID-19 pandemic in academics, as they often struggle with precarious working situations and they are seeing many doors shutting...

27 May 2020 1,440 1 View

Avigan ( Favipiravir), Hydroxychloroquine plus Azithromycin. A possible Cocktail against SARS-COV2 ?

All the three medicaments have promising results reported and supposed complementary mechanism of action?

10 April 2020 6,909 7 View

In Limma package, why should I linearize my data in some analyses?

tl;dr: Why data linearization is applied in the identification o differentially expressed genes/proteins? I am new to data analysis of big data like proteomics. As far as I know, a simple t-test...

16 November 2019 8,441 4 View

What are the do's and don'ts of good research dissemination plans?

Funding agencies increasingly ask for research dissemination plans, in particular in public health, and some require that a considerable amount of time in your project is solely dedicated to this...

17 October 2019 7,557 3 View

How do I model 3D flow through a pipe and onto a surface?

Hi, I am trying to model air flow through a pipe, that has a smaller pipe inside of it. I also have a heater in an impingement plate on the end of the pipe that the air should cool. How do I...

26 August 2019 6,699 3 View

Does anyone know of UV transparent 48 well microplates and adequate to cell culture?

I need to perform experiments with UV irradiation at 270 nm that require a 48 well plate layout. Does anyone know of UV transparent microplates with less than 96 wells? Besides, are there any UV...

05 June 2019 6,627 2 View

How to view time-averaged data in CFD-Post?

Hi, I am running a transient model in Fluent. I have checked the data sampling box under the run calculation tab. How do I view my time averaged data in CFD-post? I am trying to plot my...

03 March 2019 7,294 10 View

Could we organize collective human intelligence to achieve and surpass the breakthroughs obtained or crystallized by individual human geniuses?

The biophysicist Jacques Monod hypothesized that man will never understand itself due to that a logical system could not be higher than itself. With the internet becomes common use the somewhat...

30 January 2019 8,014 10 View

How to analyze a particular region of my simulation box in GROMACS?

Hi, I am using GROMACS 5.1.4 to simulate water in contact with a surface. I am only interested to calculate some properties of water near the surface. Let's say at a distance of x nm from the...

03 March 2021 9,989 2 View

How to get onecolumn document from standard IEEE ACCESS LateX template?

I have prepared a manuscript in IEEE Latex template, but for some purpose, I need to prepare a word file as well (detailed format is not required). Compared to two column .tex file, one column...

02 March 2021 1,830 3 View

How can the modification of garden soil cause global warming?

Hello, I am working on a soil project and I found a primary research article that tests how the modification of agricultural soil can cause global warming, using a thermal collector, however I...

02 March 2021 7,161 3 View

Does anyone know how to plot my station to a section plot on Ocean Data View (ODV)?

I made a vertical section plot with WOA .nc file on ODV, and now I want to plot my stations (csv. file) in it. Does anyone know how to import my points to the section? They are two different...

01 March 2021 3,610 1 View

Does anyone know to clarify these changes?

01 March 2021 1,290 2 View

How can I convert .vesta file to a .cif file?

I've used the "export data" option in Vesta software to convert my unit cell into a cif file however when I use that cif in atomsk it shows error such as "can't read the position of atom 0". If I...

28 February 2021 4,966 3 View

How can we use a hybrid element in Abaqus Dynamic/Explicit for impressible materials?

Hi, all! How can we use a hybrid element in Abaqus Dynamic/Explicit for impressible materials? I have not find the choice for explicit element in Abaqus CAE. I am wondering whether it is possible...

25 February 2021 9,936 2 View

No title

25 February 2021 5,713 1 View

Anyone that can help with Maxquant TMT16plex which is missing?

Hi I am very new to proteomics analysis. I have got raw files from core facility running thermofisher TMT 16plex 4 hours. I cannot find on maxquant the option TMT16Plex there is only up to 11...

25 February 2021 1,675 3 View

How to search for crystal structure for material with atomic position labelled?

I am using the crystallographic open database and materials project to search for cif file but the exact structure is not mentioned or how can I deduce that the given structure and atomic position...

23 February 2021 6,723 2 View