Is there anyone who worked on the gaussian mixture noise?

Amani Aloui @Amani-Aloui

20 April 2019 0 2K Report

Hi,

In my communication chain , i use gaussian mixture noise with two components.

Badges
Science topic

Similar topics
Filing

More Amani Aloui's questions See All

What are the exact commands on STATA 16 to conduct a meta-analysis of prevalence data?

I want to do meta-analysis to estimate the pooled prevalence of diseases for a certain population. Some studies have reported their findings as a % with CI. However the majority have reported...

14 August 2020 3,615 7 View

How to obtain the saturation point of a soil layer from the volumetric soil water content data?

Hi Would you please let me know if the following is accurate as an answer to the question: Suppose we have sensors which measure the volumetric soil water content of a soil layer for a long...

01 August 2020 8,337 3 View

Are there any publicly accessible datasets for observed/measured snowfall rate?

Hi Do you any publicly accessible ground observations which have both solid and liquid precipitation rate? Preferably for many sites in different regions. Assuming that ground measured data...

01 August 2020 9,485 3 View

Can you recommend me a journal for diabetes research in Netherland or Europe with impact factor between 2-3 ?

Hi. Please introduce me a magazine(s) that is free to print with impact factor 2-3 in the field of diabetes. thanks a lot.

20 March 2020 7,373 9 View

SSMIS wind data?

Does anyone know where I can bulk download near real time (NRT) SSMIS wind data? I know several data providers, such as CLASS NOAA, OSPO NOAA, and Remote Sensing Systems, but these are not NRT or...

26 September 2019 5,729 2 View

What is the advantage of Artificial Neural Network against regression techniques?

What is the advantage of Artificial Neural Network against regression techniques

08 June 2019 3,820 6 View

Is relation between NRG1 and neuropathic pain in STZ diabetic rats?

12 February 2019 9,041 2 View

How ca I relate between lattice strain and XRD chart andnWhat is the relation between lattice strain and the activity of the studied material?

We work in the field of catalysts for fuel cells and our work mainly related to chemistry but comment on a paper wants details about lattices strain calculations which is not our study scope

16 October 2018 10,011 2 View

Any suggestion for green-space planning (master plan) of a city?

Dear experts, I am going to work on a project related to urban green-space planning. I welcome and appreciate your suggestions and comments. The key purpose of the project is to map and analyze...

15 October 2018 5,308 3 View

Hi, i would like to ask about matlab code of ABCD matrix of a network with three barnches ?

Hi, i would like to ask about matlab code of ABCD matrix of a network with three barnches to model my channel

30 November 2017 1,809 0 View

What do I do with DLS peaks that are from the buffer?

I'm looking at the aggregation of my protein sample using DLS. Unfortunately, my buffer (20mM HEPES) also results in a set of peaks. These are at approximately 1 and 1000 d.nm. The lowest peak...

01 March 2021 9,015 2 View

What low-cut filter (high Pass frequency) to be used for response spectrum (Tripartite plots) ?

What low-cut filter (high Pass frequency) to be used for the response spectrum (Tripartite plots)? I am currently working on differentiating between hard/soft site responses in Indo-Gangetic...

21 February 2021 9,273 2 View

How to resolve Gaussian error termination " Error termination via Lnk1e in F:\G16W\l103.exe" for TS(QST3)?

When I run the job for TS(QST3) in gaseous phase, it was completed without any error. But when I add water in CPCM model it terminated with an error: Inconsistency: ModMin= 2 Eigenvalue=...

21 February 2021 3,198 2 View

How to calculate the Atomic Polar Tensor using DFT ?

Dear friends, I am a beginner at DFT calculation. I have done a structure optimization using DFT- B3LYP/6-31G*, Nevertheless, I don't know How to calculate the Atomic Polar Tensor (APT) in...

17 February 2021 9,082 3 View

Access to supercomputer resources in India?

Hello everyone, I want to perform some gaussian calculations and want to use Materials studio for my research work. Can anyone guide me how to get access to supercomputer resources in India for...

15 February 2021 8,264 3 View

Why we use feature normalization before using the Gaussian kernel in SVM?

Support vector machine

09 February 2021 6,405 3 View

FLIM Signal to noise ratio of a time series - can I use dark frames to measure noise?

I am doing an analysis on some FLIM data in the form of time series image stacks. I need their signal-to-noise ratio. Recording starts several picoseconds before the excitation pulse, so no sample...

08 February 2021 7,169 3 View

Does Gaussian 09W software take too long to give a result if we have a large chemical structure ?

DFT - gaussviev - gaussian09W - HOMO - LUMO

08 February 2021 6,012 5 View

How to eliminate noise when using a sensor with instrumentation amplifier and giving it's output to Arduino?

When I am trying to implement a pressure sensor through instrumentation amplifier and then giving it's output to Arduino, I am getting garbage value due to noise, so how to eliminate it.

05 February 2021 8,598 11 View

How to calculate enthalpy of formation of Polymers taking into account the terminal end groups?

I am trying to find methods for theoretical calculation of enthalpy of formation of Polymers. till now I have found the oligomeric method (Gaussian) which uses the extrapolation of results from...

05 February 2021 9,707 4 View