The vibration sensor (e.g. accelerator) is commonly used to monitor the vibration signal of a bearing for condition monitoring and fault diagnosis. If there any Standard for bearing vibration signal monitoring?
Dear J. Rafiee
Thank you very much for sharing, it is really helpful to me!
Regards,
Zhenyu
Instead of checking only the mRNA level, I want to check the active protein level of MMP-1 in Liver tissue from mice. How can I do that?
03 March 2021 1,763 2 View
I want to analyses the proportion of swimming sperm of three species of fish in two salinities. To analyse the proportion of swimming sperm in a Generalized Linear Model, I would use a Binary...
03 March 2021 2,297 3 View
03 March 2021 8,272 1 View
Hi. Please tell me what guidelines should i need to follow for questionaries' type research work in India. It is not hospital based work, we are conduction basic institutional based qualitative...
03 March 2021 2,037 3 View
Hi, I implemented a code to gabor filter cifar10 data but the images after being filtered and stacked are not clear like the original images. I think the problem is in the way I am using the...
03 March 2021 6,317 1 View
i am try to classify the x-ray images. During classification , can i block unwanted images (except x-ray image).
03 March 2021 7,100 1 View
03 March 2021 5,360 2 View
The term miscibility refers to the single-phase state in thermodynamics. I do not mean the compatibility of different components. To determine the miscibility I know several techniques such as...
03 March 2021 4,107 4 View
If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis
02 March 2021 7,670 3 View
02 March 2021 5,204 3 View
Hi, I am currently working on a pilot study to get some data related to the impact of long duration spaceflight to the microbiome and the immune system. I plan to use rats and simulate...
22 February 2021 592 1 View
Dear all, If steel jacketing is used to retrofit a reinforced-concrete (RC) column, can we use it to improve flexural strength? I understand that we leave gaps between the ends of the jacket and...
22 February 2021 1,906 5 View
Hello, I have a question. there is a circular thin foil which vibrates in vacuum, the foil restricted and moves up and down. it is like a diaphragm between two pipes . both sides are in vacuum but...
18 February 2021 8,075 3 View
Dear all I need some help; I am working on dynamic vibration analysis of FGM plate with piezoelectric patch using finite element modeling using MATLAB using finite element modeling
23 January 2021 3,946 3 View
Hi, Can we use FDD algorithm for forced vibration response (sinusoidal response produced from eccentric mass vibrator)? Thanks
22 January 2021 5,851 2 View
Hello everyone! First, I would like to thank you for taking time to help me out. I am a final year student, studying Aeronautical Engineering and for a project, I need to do an analysis of...
15 January 2021 7,888 3 View
This is a boundary control problem of a hybrid ODE-PDE system. The system consists of an actuator, a flexible link fixed to the actuator, and a tip mass at the free end of the link. In most...
13 January 2021 8,050 2 View
Hi All I want to simulate an ambient vibration to be used as an input to a Numerical Model. I want this to represent the vibrations occurred to the building through the wind, vehicle/human...
05 January 2021 9,228 3 View
I would like to know more about the following issues: 1. Using images as feedback for the closed-loop control of civil structures 2. Simulating the vision-guided control on the computer without...
03 January 2021 7,566 1 View
We have a one meter long copper pipe through which water passes at a certain speed. The outer wall of the tube is covered by the heater where all the energy of the heater is transferred to the...
02 January 2021 5,965 3 View