Is there any simple method to measure the singlet oxygen production by UV-Visible spectroscopy?

More Kalpana Hari's questions See All

Why is DMSO rather than Glycerol used while preparing cells for cryo, and why is glycerol used preferentially while storing microbial culture?

I would like to know which differences make these solutions suitable for these applications.

06 July 2012 5,541 11 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

Which fluorescent dye to use for measuring total ROS production?

Is DCFDA appropriate for measuring total ROS production, or can it only detect certain types of ROS? If I want to measure total ROS production, which dye should I use?

01 March 2021 9,447 3 View

Any research papers for extraction of nutrient deprivation on macroalgae? Analysed by HPLC-UV and GC/MS. Possibly from macroalgae genus Rhizoclonium?

I am doing my thesis on the nutrient deprivation on the macroalgae Rhizoclonium sp. I will be analysing the levels over a period of roughly 5 days by HPLC-UV and GC/MS. I will be using seawater as...

28 February 2021 6,477 1 View

Why initial concentration of Pb not the same as calculated one when testing using AAS?

I am currently doing research on the adsorption of heavy metal using magnetic reduce graphene oxide. I use AAS to determine the concentration of the heavy metal. I prepare the Pb solution with...

26 February 2021 9,580 4 View

Is this the write procedure for acid digestion of soil for heavy metal analysis using AAS?

How to do acid digestion of soil sample with 3:1 aquaregia in an open vessel?

23 February 2021 3,053 7 View

How can I simulate the optical absorption spectrum of a biomaterial (like DNA or protein) in COMSOL?

I need to simulate the optical properties of a biomaterial, namely DNA, in COMSOL. Basically I need to simulate the IR absorption spectrum of a cylinder filled with a 'concentration' of DNA. I am...

21 February 2021 3,043 3 View

In methylene blue test Why is UV absorbance reading very low as soon adsorbent is added and then increasing before reaching equilibrium?

Hello, I'm working on removal of methylene blue. 01. in the dark test very first reading is taken 15 minutes after adding adsorbent to the dye solution and that UV absorbance reading is very...

19 February 2021 472 5 View

Unusually Busy Raman Background?

Hello, I am observing a nearly periodic background spectrum for a wide variety of SERS substrates. I see this response (attached below) for bare Au films, Cu films, and Au nanoparticles on...

15 February 2021 9,922 5 View

Where would? can? positive charge(vacancy) be when grounded?

Hello I plasma(H2N2) treated Al2O3 plate (edge is connected to ground) and wondered if oxygen vacancy migration on the plate can occurs as electrons escape through edge. Or whatever positive...

15 February 2021 8,118 1 View

ZnS oxidizes to ZnO!!why??

when I put my ZnS solution in the chemical bath, the ZnS oxidizes so there are ZnO peaks appearing because of the reaction with the oxygen in the air, despite the fact that I close the beaker...

14 February 2021 5,778 9 View

Arunas Ramanavicius

You can employ oxygen consuming enzymes and Dyes which are accepting electrons from enzyme (actually from O2 via enzyme), formore information read this publication:

Article Spectrophotometric evaluation of gold nanoparticles as red-o...

Kalpana Hari

Thank you arunas. I hope usage of dye will provide direct results.

Cem Göl

You can monitor singlet oxygen production by chemical method with DPBF (1,3-Diphenylisobenzofuran) in organic solutions and with ADMA (anthracene-9,10-diyl-bis-methylmalonate) in aqueous solution.

Ateeq Ur Rehman

Dear Kalpana, Please have a look here on attached article for the simplest method to measure the singlet oxygen production.