Is there any kind of data available for connection properties like signal strength between UE and RAN?

More Hanif Kukkalli's questions See All

Why my gel electrophoresis have shadow bands? Please see the attached picture for the gel electrophoresis ?

Sometimes I see the shadow like bands and its not true band. I want to know that what's the reason for it. I am using 2% gel for running genotyping samples I have uploaded the gel picture in both...

19 July 2024 148 6 View

What should be the maximum length of any research paper ?

Hi Everyone! what should be the maximum length of any research paper which is extracted from PhD thesis, Any reference?

16 July 2024 5,238 4 View

Why a policy paper like "how to address trade deficit" is NOT finding place in academic journals?

Research articles aimed at addressing direct policy issues are NOT welcome by academic journal, what is the reason?

01 June 2024 5,623 5 View

Total carbohydrates calculation using phenol sulfuric method?

Hello esteemed researchers, I am seeking guidance on how to calculate the total carbohydrate content. I've observed that some researchers divide the concentration found by 0.1 and then multiply it...

14 April 2024 8,888 8 View

What is the best method to isolate CD138+ cells from frozen primary Bone Marrow MNCs?

I have collected fresh primary bone marrow samples (within 1 day) and have isolted the MNC and stored them in Nitrogen tank. I am not quite confident about which method to be used. Some say...

02 April 2024 6,814 2 View

How can I calculate concentration (mg/Kg) of pesticide residues by using the area of peak acquired using the HPLC?

How can I calculate concentation (mg/kg) of sample by using area of peak during analyzing the pesticide residues by HPLC?

25 March 2024 4,392 6 View

Query Regarding 2D Simulation with Sliding Mesh for Vertical Axis Wind Turbine: Average Torque Analysis?

Hello fellow researchers, I am currently engaged in a 2D simulation of a three-blade vertical axis wind turbine using CFD Fluent, incorporating sliding mesh simulationI. I have conducted various...

15 January 2024 7,583 2 View

Why does the stress strain curve in Abaqus of my concrete model look like this?

in the unreinforced concrete model, after reaching the maximum force, it should experience failure and no increase in force occurs. Can anyone help?

09 January 2024 6,548 3 View

How to Make Boundary Condition and continous loads?

In Abaqus, I want to create boundary conditions like the example in the attached image. But I'm having difficulty how to make it. Especially in creating continuous loads in the middle of the...

26 December 2023 8,842 5 View

How to pass multiple signals in Fractional-order Integration in SIMULINK (MATLAB)?

Here is the pasted screenshot. The FOMCON fractional-order integral block is designed for taking only a scalar signal. If I try to apply Multiple inputs to the integration (FOMCON) block it shows...

12 November 2023 1,286 0 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,141 3 View

Adhesion strength of coating?

How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...

10 August 2024 942 3 View

How can major oxides determined by ICP-MS/ES be normalized to 100% volatile free? How does this connect with LOI?

I am analyzing cherts from different sources found within one specific geologic formation using ICP-MS/ES. My committee was asking this question about my analysis. I was not sure how to answer this

05 August 2024 7,902 3 View

London dispersion in CCl4 vs the dipole-dipoles force strength in CHCl3?

How do you tie-break and rank these two in their strength?

03 August 2024 4,471 1 View

What are the limitations and challenges of using machine learning for predicting concrete compressive strength in practical applications?

Machine learning (ML) has shown great potential in predicting the compressive strength of concrete, an important property for structural engineering. However, its practical application comes with...

03 August 2024 2,546 2 View

How do environmental toxins interact with genetic predispositions to increase cancer risk?

I am currently researching the impact of environmental toxins on children's health and would greatly appreciate insights from experts in the field. If you are an expert or researcher working on...

02 August 2024 2,627 1 View

I am working on III-V based tandem solar cells.Can anyone explain that solar cells work under forward or reverse biased conditions?

I want to know that n-doped side of solar cell is connected with positive or negative electrode.

20 July 2024 1,348 2 View

Trial exclusion in eye-tracking data?

Is it reasonable to exclude all trials with a blink or saccade in the 150 ms before stimulus onset? As an alternative, would it be better to exclude blinks (after extending them by about 100 ms...

19 July 2024 3,838 0 View

A twin-shaft kiln or a rotary kiln for lime production 1 class? if compressive strength of limestone is low 60 MPa?

My research work is related to the calcination of limestone. I have a complex question and would like to consult with experts in this field. Could you please advise which kiln to choose (a...

18 July 2024 1,390 2 View

I need to connect expert in Urban design for Health ?

I studying PhD course in Urban design for Health. I need to know in some fileds: residental block, green open space and Transport TOD. I need connect with expert in that fileds.

14 July 2024 1,892 3 View

Chinaza Godswill Awuchi Popular answer

Also check https://link.springer.com/article/10.1186/s13638-019-1596-9

Gunta Raca

Hello!

Thanks for the message, I think that Emils Sundjukovs, [email protected] will be better able to answer this question.

Chinaza Godswill Awuchi

Check https://www.etsi.org/deliver/etsi_ts/138400_138499/138401/15.02.00_60/ts_138401v150200p.pdf

And https://www.hindawi.com/journals/wcmc/2019/3170694/